Loading ...
Loading ...
Loading ...
ASSEMBLINGSTEELLEGS
NOTE: Steel Legs are furnished with Model 113.295820.
From among the loose parts, find the following Hardware: ......
24 Truss Head Screws; 1/4 in. - 20 x 5/8 in. long (top
of screw is rounded)
24 Lockwashers, 1/4 in. External Type (approx. dia. of
hole 1/4 in.)
24 Hex Nuts, 1/4 in. - 20 (approx. dia. of hole 1/4 in.)
8 Hex Nuts, 1/2 in. - 13 (approx. dia. of hole 1/2 in.)
4 Leveling feet.
Assemble the legsasshown...
1. Insert the Truss Head Screws through the holes in the
legs, then through the holes in the stiffeners. MAKE
SURE THE SCREWS GO THROUGH THE HOLES IN
THE SIDE STIFFENERS MARKED "X".
2. Screw on the nuts but do not tighten until completely
assembled.
3. Install leveling feet.
END
STIFFENER"
SCREWSTHROUGH
HOLESMARKED"X"
\
SIDE STIFFENER
IN. HEX NUTS
MOUNTING SAW
1. Remove the four Truss Head screws, flatwashers,
Iockwashers and nuts from bottom of saw.
2. Position legs as shown and line up holes in stiffeners
with holes in saw base.
NOTE: At front of saw you will see four sets of holes,
Insert bolts through holes closest to front of saw . . .
these holes are 9-1/4" apart.
Replace the screws, washers and nuts . . . tighten the
nuts.
3. Place saw in upright position.
\
If you mount the saw on any other bench, make sure that
there is an opening in the top of the bench the same size as
the opening in the bottom of the saw so that the sawdust
can drop through. Recommended working height is 33 to
37 in. from the top of the saw table to the floor.
NOTE: All dimensions in inches.
10
1/2 1/4
FRONT OF SAW
4 HOLES
7/16 DIA.
Loading ...
Loading ...
Loading ...