Loading ...
Loading ...
Loading ...
EN - 11
13. PROBLEM IDENTIFICATION
PROBLEM PROBABLE CAUSE REMEDY
1. The motor does
not start when the
switch is pressed
Safety key is not inserted or is inserted
incorrectly
Battery is not inserted or is
inserted incorrectly
Open the hatch and check that the battery is
Low battery Check the battery status and
Motor start-up is slow Press and hold the control lever
The thermal protection has tripped
due to overheating of the motor
Wait for at least 5 minutes and then restart
the machine
2. The motor shuts
down whilst working
Battery is not inserted correctly Open the hatch and check that the battery is
Low battery Check the battery status and
Obstructions that prevent
rotation of the cutting means
gloves and remove any grass remains
or debris from the lower part of the
machine and/or the discharge channel
The motor stops while
working and the machine
alarm buzzer is triggered
The thermal protection has tripped
due to overheating of the motor
Wait for at least 5 minutes and then restart
the machine
Thermal protection has tripped due to
• excessively high grass cutting
• obstructions that prevent
rotation of the cutting means
• too much grass debris accumulated in
the chassis and discharge channel
• Set a higher cutting height when the
height and cut the lawn again
•
•
Wait for at least 5 minutes and then restart
the machine
4. The motor is running
but the cutting means
is stationary
and remove the safety key.
Contact an authorised Technical Assistance
Centre for correct fastening support (par. 7.5)
5. The cut grass is
not collected in the
grass catcher
The cutting means has collided with a
and remove the safety key.
Inspect for damage and
Contact a Technical Assistance Centre
for the replacement of the cutting
means if necessary. (par. 7.5)
The inside of the chassis is dirty Clean the inside of the chassis to
ease the grass discharge towards
The cutting means is not
in good condition
Contact a Technical Assistance
Centre for the sharpening or
replacement of the cutting means
7. Excessive noise
and/or vibration
is experienced
whilst working
the cutting means is damaged
and remove the safety key.
Contact an authorised Technical
Loading ...
Loading ...
Loading ...