Loading ...
Loading ...
Loading ...
EN - 7
4. Completely close the hatch again.
5.
button (Fig. 12.A) and then pressing the operator
presence lever (Fig. 12.B)
6.
handle (Fig. 12.C)
6.4 WORKING
IMPORTANT When working, always keep
a safe distance from the cutting means,
given by the length of the handle.
Battery power reserve (therefore the mowable lawn surface
before recharging is required) depends on many factors
described in (par. 7.2.1).
IMPORTANT If the motor stops while mowing due to
overheating, you must wait approximately 5 minutes before
restarting it.
6.4.1 Grass cutting
1. Start moving forward and mowing in the grass area;
2. Regulate the forward speed and the cutting height
(par. 5.4) considering the conditions of the lawn (the
amount of grass collected;
3. The appearance of the lawn will improve if you alternate
4. Never cut more than one third of the total grass height
per single pass (Fig.14).
5. It is recommended to avoid mowing on slopes with a
degree higher than 15°.
6.4.2 Emptying the grass catcher
changes.
Alzato = vuoto. Abbassato =
pieno*.
remains raised for as long as the grass catcher is able
catcher is full and must be emptied.
1. release the switch lever and wait for the cutting means
2.
handle and remove the grass catcher keeping it in an
erect position.
6.5 STOPPING THE MACHINE
1.
2.
When you have stopped the machine, it will
take a few seconds for the cutting means to stop.
IMPORTANT Always stop the machine:
- when moving between work areas;
- when driving on grass free surfaces;
- every time it is necessary to overcome an obstacle;
- before adjusting the cutting height.
- whenever you remove or reattach the grass catcher.
6.6 AFTER OPERATION
1.
2. Open the hatch and remove the safety key.
3. Remove the battery from its housing and recharge it
4. Allow the motor to cool before storing in an enclosed
space.
5.
6. Check there are no loose or damaged components.
tighten any screws and loose bolts or contact the
authorised service centre.
IMPORTANT Remove the safety key whenever the
machine is unused or left unattend
7. MAINTENANCE
7.1 GENERAL INFORMATION
The safety regulations to follow are described
in chap. 2. Strictly comply with these instructions to
avoid serious risks or hazards.
Before conducting any inspections, cleaning
or maintenance/adjustment interventions on the
machine:
• stop the machine;
• remove the safety key, (never leave the key in the
ignition or within reach of children or unauthorised
persons);
• make sure that all moving parts have come to a
complete stop;
• allow the motor to cool before storing in an enclosed
space.
• read the relevant instructions;
• Use suitable clothing, protective gloves and
goggles.
• The frequency and types of maintenance are summarised
in the "Maintenance Table". The table will help you
maintain your machine’s safety and performance. It lists
the main maintenance tasks and how often they need to
be performed. Carry out the relevant task as soon as it is
scheduled to be performed.
• The use of non-genuine and/or incorrectly assembled
machine operation and safety. The manufacturer shall
Loading ...
Loading ...
Loading ...