Loading ...
Loading ...
Loading ...
5.1 GENERAL SAFETY INSTRUCTIONS FOR LASER USE
Laser radiation. Do NOT stare into beam. Class || laser product.
Viewing the laser output with certain optical instruments (for example, eye loupes, magnifiers and
microscopes) with a distance of 100mm may pose an eye hazard.
Viewing the laser output with optical instruments designed for use at a distance (for example,
telescopes and binoculars) may pose an eye hazard.
Do NOT direct the beam towards a person’s eye.
Avoid positioning the laser such that it may lead to unintentional eye exposure to any potential
passing pedestrians/traffic.
Do NOT direct the beam towards animals.
Do NOT direct the beam towards aircraft or moving vehicles.
Do NOT use in the vicinity of children.
Do NOT direct the beam onto reflective surfaces.
Always switch off when not in use and do not leave unattended. Remove the batteries before
storing the laser level away.
Store the level in a dry location, out of reach of children.
Care must be taken to ensure that the laser level is not dropped, knocked or damaged during use
or storage.
This laser level product has no serviceable parts. Do not attempt to disassemble or repair.
(12)
(13)
(14)
– At the end of the machine’s working life, or when it can no longer be repaired, ensure that it is
disposed of according to national regulations.
– Contact your local authority for details of collection schemes in your area.
In all circumstances:
Do not dispose of power tools with domestic waste.
Do not incinerate.
Do not abandon in the environment.
Do not dispose of WEEE* as unsorted municipal waste.
* Waste Electrical & Electronic Equipment.
5. GENERAL SAFETY INSTRUCTIONS
- 6 -
(1)
(2)
(3)
(4)
(6)
(7)
(8)
(9)
(10)
(11)
(5)
(3)
(6)
(11)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(5)
(12)
(13)
(14)
Slide the battery compartment cover (5) up slightly
before lowering it down to remove it. Insert the 3 x AA
batteries, taking note of the polarity indicated inside the
compartment. Replace the cover securely.
Ensure the laser beam aperture is covered to
avoid accidental beam exposure during battery
installation/replacement.
Remove the tripod from the case, extend all the legs and place the tripod into position.
Ensure the locking screw on the side of the tripod is tight. Adjust the height of each leg individually
to align the bubble on the top of the tripod as near as possible to the centre of the circle.
Remove the rotary base and screw onto the tripod taking care not to disturb its position. Using the
three adjusters, align the bubble on the rotary base as near to the centre of the circle as possible
then align the bubble on the self-levelling laser level as near to centre of both vials.
To fine tune the rotary base, place the level centrally into the clamp and tighten. Rotate the level
clockwise until it is directly over one of the three adjusters. Turn the adjuster until the horizontal
vial is level. Rotate the level a further 120° clockwise and adjust it to horizontal. Rotate the level a
further 120° to complete the final adjustment.
If the location of the height of the tripod is changed these adjustments must be repeated.
Loosen the transportation lock (11) prior to use.
Select the vertical line with button (3) or the horizontal
line with button (6) or both for a cross.
Wearing the goggles supplied will enhance the
laser beam. The beam will remain level providing the
error margin does not exceed 6°(+/-).
Do not dispose of WEEE*
unsorted municipal waste.
Loading ...
Loading ...
Loading ...