360° ROTATING SELF-LEVELLING
LASER LEVEL
KIT
(12)
(13)
(14)
– At the end of the machine’s working life, or when it can no longer be repaired, ensure that it is
disposed of according to national regulations.
– Contact your local authority for details of collection schemes in your area.
In all circumstances:
Do not dispose of power tools with domestic waste.
Do not incinerate.
Do not abandon in the environment.
Do not dispose of WEEE* as unsorted municipal waste.
* Waste Electrical & Electronic Equipment.
(1)
(2)
(3)
(4)
(6)
(7)
(8)
(9)
(10)
(11)
(5)
(3)
(6)
(11)
88640
These instructions accompanying the product are the original instructions. This document is part of the product, keep
it for the life of the product passing it on to any subsequent holder of the product. Read all these instructions before
assembling, operating or maintaining this product.
This manual has been compiled by Draper Tools describing the purpose for which the product has been designed,
and contains all the necessary information to ensure its correct and safe use. By following all the general safety
instructions contained in this manual, it will ensure both product and operator safety, together with longer life of the
product itself.
AlI photographs and drawings in this manual are supplied by Draper Tools to help illustrate the operation of the
product.
Whilst every effort has been made to ensure the accuracy of information contained in this manual, the Draper Tools
policy of continuous improvement determines the right to make modifications without prior warning.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(5)
(12)
(13)
(14)
Slide the battery compartment cover (5) up slightly
before lowering it down to remove it. Insert the 3 x AA
batteries, taking note of the polarity indicated inside the
compartment. Replace the cover securely.
Ensure the laser beam aperture is covered to
avoid accidental beam exposure during battery
installation/replacement.
Remove the tripod from the case, extend all the legs and place the tripod into position.
Ensure the locking screw on the side of the tripod is tight. Adjust the height of each leg individually
to align the bubble on the top of the tripod as near as possible to the centre of the circle.
Remove the rotary base and screw onto the tripod taking care not to disturb its position. Using the
three adjusters, align the bubble on the rotary base as near to the centre of the circle as possible
then align the bubble on the self-levelling laser level as near to centre of both vials.
To fine tune the rotary base, place the level centrally into the clamp and tighten. Rotate the level
clockwise until it is directly over one of the three adjusters. Turn the adjuster until the horizontal
vial is level. Rotate the level a further 120° clockwise and adjust it to horizontal. Rotate the level a
further 120° to complete the final adjustment.
If the location of the height of the tripod is changed these adjustments must be repeated.
Loosen the transportation lock (11) prior to use.
Select the vertical line with button (3) or the horizontal
line with button (6) or both for a cross.
Wearing the goggles supplied will enhance the
laser beam. The beam will remain level providing the
error margin does not exceed 6°(+/-).
Do not dispose of WEEE*
unsorted municipal waste.
Loading ...
Loading ...
Loading ...
