Loading ...
Loading ...
Loading ...
EN - 30
PROBLEM PROBABLE CAUSE REMEDY
10. The engine stops
running and an acoustic
signal is generated
The safety device of the electronic
circuit board has cut in due to:
Turn the ignition key to «STOP» position
and identify the cause of the problem:
over-voltage caused by
the charger regulator
contact your Dealer
battery not connected
correctly (poor contacts)
check the connections (see 3.4)
11. The engine stops
running, and no
acoustic signal
is generated
battery disconnected check the connections (see 3.4)
engine problems contact your Dealer
12. The cutting device do
not engage or do not
stop promptly when
they are disengaged
loose belt contact your Dealer
problems with the electro-
magnetic clutch
contact your Dealer
13. Uneven mowing and
insucient collection
(for rear collection
models only)
cutting device assembly is
not parallel to the ground
check the tyre pressure (par. 6.1.3)
reinstate the alignment of the cutting device
assembly in relation to the ground (par. 8.2.1)
inecient cutting device contact your Dealer
forward speed too high
compared to height of grass
reduce the forward speed and/or raise
the cutting device assembly (par. 6.5.4)
wait for the grass to dry
collector chute is blocked remove the grass catcher bag and
empty the chute (see 7.6.2)
14. Uneven mowing (side
discharge models only)
cutting device assembly is
not parallel to the ground
check the tyre pressure (par. 6.1.3)
reinstate the alignment of the cutting device
assembly in relation to the ground (par. 8.2.1)
inecient cutting device contact your Dealer
15. Unusual vibrations
while working
cutting device assembly is full of grass clean the cutting device assembly (par. 7.6.4)
the cutting device are
unbalanced or loose
contact your Dealer
loose bolts and screws check and tighten all the
engine and frame bolts
16. Uncertain or
ineective braking
the brake is not adjusted correctly contact your Dealer
17. Erratic forward
movement, poor drive
when going uphill or
if the machine has a
tendency to rear up
problems with the belt or the
engagement device
contact your Dealer
18. When the engine is
running, the machine
remains stationary
when the drive
pedal is pressed
release lever in the gear
disengagement position
return it to the gear engaged
position (par. 5.4)
If problems persist after having performed the above operations, contact your Dealer.
Loading ...
Loading ...
Loading ...