Loading ...
Loading ...
Loading ...
6
INTRODUCTION
Thank you for choosing this De’Longhi product. Please take a few
minutes to read these instructions. This will prevent running any
risks of or damaging the appliance.
DESCRIPTION
Description of the appliance (see page 2 - A)
A1 Air outlet grille
A2 Control panel
A3 Handles
A4 Wheels
A5 Filter
A6 Air intake grille
A7 Air exhaust hose housing
A8 Air intake grille
A9 Power supply cable
A10 Upper drainage outlet with cap
A11 Lower drainage outlet with cap
A12 Remote control signal receiver
A13
Remote control compartment
Description of accessories (See page 2 - B)
B1 Air exhaust hose
B2 Hose adapter
B3 Adapter for extendable window bracket/ window
B4
Extendable window bracket with screws
B5 Drainage hose
B6 Self adhesive strips foam (2 pieces)
B7 Non adhesive strip foam
B8 Remote control
ELECTRICAL CONNECTION
Before plugging into the outlet, check the following:
• the outlet voltage is the same as that indicated on the plate
on the back of the appliance;
• the socket and electrical line are sized to support the load
required;
• the socket is the proper type for the plug, otherwise, re-
place the socket;
• the socket is connected to an ecient grounding sys-
tem. The manufacturer is not responsible in the event of
non-compliance with these injury prevention standards.
• The power cable must only be replaced by special-
ized technicians.
USE
The instructions below will enable you to prepare your air con-
ditioner for operation as eciently as possible. Before use, make
sure the air intake and outlet grilles are unobstructed.
Maintain a minimum distance of 2ft/60 cm from walls and ob-
stacles. In air conditioning and dehumidication mode the air
exhaust hose (B1) must be applied (see gure 1).
A
B
1
Please note: This appliance is provided with an auto-evapora-
tion feature for condensate removal during cooling and dehu-
midifying mode.
AIR CONDITIONING INSTALLATION
For optimal results see the figures below for
the suggested minimum distances.
NOTE: Philips head screwdriver required for installation of win-
dow kit.
DOUBLE-HUNG WINDOW
If you have a double-hung window proceed as follows:
• Fit the air exhaust hose (B1) in the relevant housing located
on the rear side of the appliance (g. 1).
Depending on the need, place the self adhesive strips foam or
non adhesive strip foam on the window as shown in gure 2.
2
60 cm
60 cm
24 in
60 cm
24 in
24 in
Loading ...
Loading ...
Loading ...