Loading ...
Loading ...
Loading ...
MAINTENANCE
3. Clean Battery and Terminals
Corrosion and dirt on the battery and terminals cause the
battery to "leak" power and hinders the operation of the
charger.
a. Remove terminal guard.
b.
Remove the battery from the tractor and wash
with four tablespoons of baking soda to one
gallon of water. NOTE: BE CAREFUL NOT TO
GET THE SODA SOLUTION INTO THE CELLS.
c . Clean terminals and cable ends with a wire brush
until bright.
d. Rinse the battery with plain water, dry and
reinstall on tractor.
e . Replace cables and terminal guard. Refer to page
8.
4. Change Engine Oil
The best time to drain engine oil is at the end of a day's
operation when all dirt and foreign materials are suspend-
ed in the hot oil. Refer to page t 5.
5. Lubricate Pivot Points
Place several drops of S.A.E. 30 oil at points where parts
move against each other, especially:
a. Front Axle Pivot
b. Hood Hinges
c. Foot Pedal Shaft (both ends)
d. Lift Shaft (both ends)
e. Sector gear end pivot points
Lubrication Chart
SPINDLE
@WHEEL BEARINGS--_
BOTH ENDS OF
FOOT PEDAL
SAE 30 (SC, SD OR SE)
MOTOR OIL
CHASSIS GREASE
SEARS PART NO. 2557R
_ REFER TO ENGINE OIL SPEC'S.
(UNDER INITAL PREPARATION
IN OWNERS MANUAL)
CHASSIS GREASE
WITH BRUSH
i_ SPINDLE @
_ WHEEL
ENGINE (_
SECTOR GEAR
BEARINGS @
--BOTH ENDS LIFT SHAFT@
TRANSAXLE
(CHECK LEVEL AT REAR
FILL PLUG) @
18
Loading ...
Loading ...
Loading ...