Loading ...
Loading ...
Loading ...
INITIAL INSTALLATION
DOWNROD-STYLE FAN MOUNTING
1.
Remove pin (K) and clip (L) from yoke at top of
motor housing (D) and partially loosen
preassembled set screws and nuts.
7
Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket
(C) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is
installed facing the higher point of the ceiling, and
ensure the ceiling angle is not steeper than 19°.
4.
5.
Remove motor screws (H) and lock washers (I)
from underside of motor housing (D). [If there are
plastic motor blocks installed with the motor
screws (H) and lock washers (I), discard the
plastic motor blocks.]
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below. For
CLOSEMOUNT-STYLE FAN MOUNTING, skip
to page 9.
4
Open End
C
C
ANGLE MOUNTSTANDARD MOUNT
I
H
5
D
Plastic Motor Block
Set
Screw
and Nut
1
L
K
Yoke
D
Loading ...
Loading ...
Loading ...