Loading ...
Loading ...
Loading ...
6 7
INSTALLATIONTROUBLESHOOTING
480mm
560mm
*
Gas supply connection location
830mm
Gas supply connection location
*
480mm
Figure 4–60cm and 75cm models cut-out
Figure 4–90cm models cut-out
INSTALLATION INSTRUCTIONS
This appliance must be installed by an authorised person
and in compliance with :
1. AS/NZS 5601.1 Gas Installations Part 1: General
Installations, and AS/NZS 5601.2 Gas Installations
Part 2: LP Gas installations in caravans and
boats for non-propulsive purposes, or the relevant
installation code for gas appliances in your country.
2. The local gas fitting regulations, municipal building
codes, electrical wiring regulations and any other
relevant statutory regulations.
3. The particular instructions as given below.
CAUTION
Cooktops are supplied for use with natural gas (NG).
To use on LPG the injectors MUST be changed using
the conversion kit supplied. Refer LP Conversion on
page 12.
4. A certificate of compliance MUST be given to the
customer after the appliance is successfully installed.
5. This appliance must be earthed.
FAULT POSSIBLE CAUSES REMEDY
Burner will not light
even though the sparker
is working.
• Knob not held down long enough
in ‘High’ position for flame safeguard
(where fitted) to engage
• Repeat lighting procedure and hold knob
down for 5 seconds in ‘High’ position
(refer page 4)
• Gas supply valve turned off • Turn on gas supply to appliance
• Wrong knob turned • Ensure the knob you are turning corresponds
to the burner you want to light
• Port blockage in ignition area • Ensure that ports in ignition area are clean
and dry
• Ignition spark plugs wet or dirty • Dry or clean ignition spark plugs
No spark is obtained
when control knob
is activated
• Electricity supply is disconnected or
switched off
• Switch on electricity or check fuses
• Ignition spark plugs wet or dirty • Dry or clean ignition spark plugs
Flames uneven or
tending to lift
• Flame ports blocked or wet • Clean or dry ame ports
• Burner incorrectly tted • Ensure this component is tted correctly
Flames not staying on
when knob released
• Knob not held down long enough
in ‘High’ position for flame safeguard
(where fitted) to engage
• Repeat lighting procedure and hold knob
down for 5 seconds in ‘High’ position
(refer page 4)
• Knob not set between ‘High’ and
‘Low’
• Knob MUST be set between these positions.
• Dirt or spillage on ame safeguard
sensor (where fitted)
• Clean ame safe guard sensor tip
Low heat, slow cooking
• Incorrect cooking pot or pan being used • Refer to Figure 3 (page 5)
Benchtop or knobs
overheating
• Incorrect cooking pot or pan used • Check Figure 3 for correct pot or pan to be used
• Pot or pan not located on burner
properly
• Ensure pot or pan is centrally located
on burner
If you have a problem with the cooktop, check the table below. You may be able to solve the problem and this will
save you from paying for a service call. You will have to pay for a service call even in the warranty period if the
problem is one listed below.
If the above points have been checked and there is still a problem with the cooktop, please call the Service Centre.
Loading ...
Loading ...
Loading ...