Loading ...
Loading ...
Loading ...
Belts
Disconnect cleaner from electrical outlet.
WARNING; Agitator brushroll can start suddenly. Unplug cleaner before turning it over,
The belts are located under the bottom plate of the cleaner and should be checked from time to time
to be sure they are in good condition,
Replacing Flat Belt
Replace bett if it is stretched, cut or broken_ To check the flat belt, refer to Fig_ 4-t3_
Removing Bottom
Plate Removing Belt Positioning Belt
Place handle in low
position and turn
cleaner over so bottom
side is facing up.
Remove the 6 screws as
shown with aPhillips
screwdriver,
Lift offbottom plate.,
Remove used belt (A)
from large pulley (B}
and discard.
Flat Belt: What to Buy
Use only genuine HOOVER® belts with your
cleaner. When purchasing a new belt, ask for
Flat belt - HOOVER® part No. 4020!-271,
With lettering on
outside of belt, slide
new bett over motor
shaft (A)o
Place other end of
belt over large pulley
{B) while rotling the
pulley in direction
shown,
Turn agitator brushrol] making sure belt turns
freely and is not pinched between agitator
brushrolI and agitator shield.
Reposition bottom plate
and 6 Phillips head
screws,Tighten screws
securely,
Inspecting V-Belt
TheV-belt isdesigned to last for a long time and
is not normally replaced. However, ifthe V-belt is
cracked, gouged or broken, it should be replaced.
Slide flat belt off large pulley as shown in Fig, 4-14_
To remove V-belt, slide back of belt over pulley (A].
Then firmly pull on belt and "snap" it out,
Discard usedbelt.
To install new belt (with lettering on outside of
belt), slide back of belt over pulley and pu11front of
belt toward groove (B) next to pl,tley. Belt will "pop" into place.
V-Belt: What to Buy
Use only genuine HOOVER®belts with your cleaner. When purchasing a
new belt, ask for V belt -HOOVER ®part No. 40201-200.
lnsert agitator
brushroll through belt
and position belt in
groove (A) on agitator
brushrolI,
11
Loading ...
Loading ...
Loading ...