Loading ...
Loading ...
Loading ...
Filters (cont.)
Seeondary Filter: How to Clean
Disconnect cleaner from electrical outlet. Do not
use cleaner without dirt cup orfilters in place.
Remove dirt cup as described in Fig. 4-2.
With thumb and forefinger, slide latch (At located at the
top of the housing to the right and pull down to remove
gray filter frame. Remove black foam filter. Rinse filter
frame cartridge and foam filter under cold water,
Allow both filter frame and filter to air dry for 24 hours
before replacing filter intofilter flame, Reposition filter
frame cartridge by inserting tabs into slots on back of
housing_ Rotate filter cartridge frame up toward top of
housing and snapclosed.
Secondary Filter: What to Buy
When purchasing a new secondary filter cartridge, ask for HOOVER®part No. 93002517.
Topurchase a new black foam filter, ask for HOOVER®part Noo930025tB.
HEPA Final Filter: How to Clean
Disconnect cleaner from electrical outlet. Do not use cleaner without dirt cup or filters in place.
With fingers in slots, pull filter
frame (A)straight out.
Dirt and debris can be cleaned from
thefilter cartridgebybrushing with
the cleaner'scombination tool.
HEPA Final Filter: What to Buy
When purchasing a new HEPA filter
cartridge, ask for HOOVER®part No_
93002360°
DO NOT R1NSE OR WASH the
HEPA filter cartridge€
Slide back into position on cleaner,
Headlight
Disconnectcleaner from electrical outlet,
Removing Lens Installing Bulb Replacing Lens
Press handle release pedal and place handle
in low position.
Using a Phillipsscrewdriver, remove the the
screw asshown and lift off lens,
Headlight: What to buy
This cleaner uses a 13 volt, T-3 114 wedge
base bulb, When purchasing a new tightbulb,
ask for Hoover part No, 27313-t07
t0
Pul!oldbulbstraight
outofsocket,Push
new bulbstraight
into socket until
locked in place.
Excessive Force is
not required.
Reposition lens and
secure with the screw.
Loading ...
Loading ...
Loading ...