Loading ...
Loading ...
Loading ...
WIHTERSTORAGE
ty NOTICE
ou must protect your unit from freezing temperatures.
Failureto do so will permanentlydamageyour pumpand
renderyour unit inoperable.
Freezedamageis not coveredunderwarranty.
To protect the unit from freezing temperatures:
1. Follow steps 1-4 in the previous section After Each Use.
2. Use pump saver, available at Sears retail item 6039, to
treat pump. This minimizes freeze damageand lubricates
pistons and seals.
3. If pump saver is not available, connect a 3-foot section
of garden hose to water inlet adapter. Pour
RV-antifreeze (antifreeze without alcohol) into hose. Pull
recoil handle twice. Disconnect 3-foot hose.
4. Store unit in a clean, dry area.
LOHGTERM STORAGE
If you do not plan to use the pressure washer for more than
30 days, you must prepare the engine and pump for long
term storage.
It is important to prevent gum deposits from forming in
essential fuel system parts such as the carburetor, fuel filter,
fuel hose or tank during storage. Also, experience indicates
that alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to separation
and formation of acids during storage. Acidic gas can
damagethe fuel system of an engine while in storage.
Protect FueJSystem
Fuel Additive:
Fuelcan becomestale when stored over 30 days. Stale fuel
causes acid and gum deposits to form in the fuel system or
on essential carburetor parts. To keep fuel fresh, use Briggs
& Stratton FRESHSTART® fuel stabilizer, available as a liquid
additive or a drip concentrate cartridge.
There is no needto drain gasoline from the engine if a fuel
stabilizer is added according to instructions. Run the engine
for 2 minutes to circulate the stabilizer throughout the fuel
system. The engineand fuel can then be stored up to
24 months.
If gasoline in the engine has not beentreated with a fuel
stabilizer, it must be drained into an approved container. Run
the engine until it stops from lack of fuel. The use of a fuel
stabilizer in the storage container is recommendedto
maintain freshness.
Change Oil
While engine is still warm, drain oil from crankcase. Refill
with recommended grade. See Changing EngineOil.
Oil CyJinder Bore
• Removespark plug and pour about 1/2 ounce (15 m]) of
clean engine oil into the cylinder.
• Install spark plug and pull starter handle slowly to
distribute oil.
Battery Storage
Store your unit with the DC battery charger plugged in to
keepyour battery charged and ready for use. if your unit is
stored below freezing temperatures, charge the battery for 24
hours prior to storage. Be sure to charge the battery once a
month to maintain a fully charged battery.
Protect Pump
NOTICE
You must protect your unit from freezing temperatures.
i ailureto do so will permanentlydamageyour pumpand
renderyour unit inoperable.
Freezedamageis not coveredunderwarranty.
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 6039, to treat
pump. This prevents freeze damageand lubricates pistons
and seals.
NOTE:PumpSaveris available as an optional accessory. It is
not included with the pressurewasher. Contact your local
Searsservice center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned
off and disconnected from supply water. Readand follow all
instructions and warnings given on the PumpSavercontainer.
Other Storage Tips
1. Clip the blue cap of the PerfectMixTM siphon to the
wireform bracket when siphon is not in a concentrate
bottle.
2.
Store clear siphon tube by winding it into a 6 inch loop
and restrain with wire ties with paper sleeve. Do not
store clear siphon for long periods with kinks in tube.
3. DO NOTstore fuel from one seasonto another unless it
has beentreated as described in Protect Fuel System.
4. Replacefuel container if it starts to rust. Rust and/or dirt
in fuel can cause problems if it's used with this unit.
5. Coverunit with a suitable protective cover that does not
retain moisture.
WARHIHG
,_ Storagecovers can be flammable.
• DONOTplacea storagecoverovera hot pressurewasher.
• Letequipmentcoolfor a sufficienttime beforeplacingthe
coveronthe equipment.
6. Store unit in a clean and dry area.
22
Loading ...
Loading ...
Loading ...