Loading ...
Loading ...
Loading ...
Troubleshooting,Adjustmflts,& Service
Rider Troub/eshooting Continued.
PROBLEM
Engine runs, but rider will
not drive.
Rider drive belt slips.
Brake will not hold.
Rider steers or handles poorly.
CAUSE
1. Hydraulic release valve(s)
in "open" position.
2. Belt is broken.
3. Drive belt slips.
4. Brake is not fully released.
1. Pulleys or belt greasy or oily.
2. Belt stretched or worn.
1. Brake is incorrectly adjusted.
2. Brake caliper pads worn.
1. Steering linkage is loose.
2. Improper tire inflation.
REMEDY
1. Turn valve(s) clockwise to close.
2. See Drive Belt Replacement.
3. See problem and cause below.
4. See authorized service dealer
1. Clean as required.
2. Replace belt.
1. See Brake Adjustment.
2. See your dealer.
1. Check and tighten any loose connections.
2. See Regular Maintenance Section.
TROUBLESHOOTING THE MOWER
PROBLEM CAUSE REMEDY
Mower will not raise. 1. Lift linkage not properly attached 1. See authorized service dealer for repair.
or damaged.
Mower cut is uneven. 1. Mower not leveled properly. 1. See Mower Adjustment.
2. Rider tires not inflated 2. See Regular Maintenance Section.
equally or properly.
Mower cut is rough looking. 1. Engine speed too slow. 1. Set throttle to full.
2. Ground speed too fast. 2. Decrease Ground Speed.
3. Blades are dull. 3. Sharpen or replace blades.
See Mower Blade Service.
4. Clean or replace belt as necessary.
Engine stalls easily with
mower engaged.
Excessive mower vibration.
Excessive belt wear or breakage.
Mower drive belt slips
or fails to drive.
4. Mower drive belt slipping
because it is oily or worn.
5. Blades not properly fastened
to arbors.
1. Engine speed too slow.
2. Ground speed too fast.
3. Cutting height set too low.
4. Discharge chute jamming
with cut grass.
1. Blade mounting bolts are loose.
2. Mower blades, arbors,
or pulleys are bent.
3. Mower blades are out
of balance.
4. Belt installed incorrectly.
1. Bent or rough pulleys.
2. Using incorrect belt.
1. Idler pulley spring broken or not
properly attached.
2. Mower drive belt broken.
5. See Servicing the Mower Blades.
1. Set to full throttle.
2. Decrease Ground Speed.
3. Cut tall grass at maximum cutting
height during first pass.
4. Cut grass with discharge pointing toward
previously cut area.
1.Tighten to 45-55 ft.lbs. (61-75 N.m.).
2. Check and replace as necessary.
3. Remove, sharpen, and balance blades.
See Maintenance Section.
4. Reinstall Correctly.
1. Repair or replace.
2. Replace with correct belt.
1. Repair or replace as needed.
2. Replace drive belt.
22
Loading ...
Loading ...
Loading ...