Loading ...
Loading ...
Loading ...
RegularMaJflteflaflce
WARNING
For your personal safety, do not handle the sharp
mower blades with bare hands. Careless or
improper handling of blades may result in serious
injury.
, WARNING
For your personal safety, blade mounting
capscrews must each be installed with a
hex/spline washer and spring washer, then
securely tightened. Torque blade mounting
capscrew to 45 - 55 ft. Ibs. (61 - 75 N.m.)
SERVICING THE MOWER BLADES
Service Interval: Every 10 Hours or As Required
1. Remove mower deck (see "Mower Deck Removal").
2. See Figure 13. To remove blade for sharpening, use
a block of wood to prevent blade rotation while loos-
ening the capscrew.
3. Remove the capscrew (D, Figure 15), spring washer
(C), hex washer (B), and blade.
4. Use a file to sharpen blade to a fine edge. If blade is
damaged, it must be replaced.
5. Balance the blade as shown in Figure 14. Center the
blade's hole on a nail lubricated with a drop of oil. A
balanced blade will remain level.
6. Reinstall the blade (Figure 15) with the tabs pointing
up toward the mower deck as shown.
7. Reinstall the hex washer (B, Figure 15), spring wash-
er (C) and capscrew (D). Use a wooden block (A) to
prevent blade rotation while tightening the capscrew
(D) to 61-75 N.m (45-55 ft. Ibs.).
LOOSEN
Figure 13. Blade Removal
Nail
Figure 14. Balancing The Blade
Figure 15. Blade Installation
A. 4x4 Wood Block
B. Hex Washer
C. Spring Washer
D. Blade Capscrew
18
Loading ...
Loading ...
Loading ...