Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART
PBOBLEM CAUSE CORRECTION
Mower blades will 1. Obstruction in clutch 1. Remove obstruction,
not rotate mechanism.
2. Worn/damaged mower 2. Replace mower drive belt.
drive belt.
3, Frozen idler pulley. 3. Replace idler pulley.
4. Frozen blade mandrel. 4. Replace blade mandrel.
Poor grass 1. Engine speed too slow.
discharge
Headlight(s)not
working
(if so equipped)
Battery will not
:harge
2. Travel speed too fast.
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air
pressure.
6. Worn, bent or toose blade,
7. Buildup of grass, leaves
and trash under mower.
8. Mower ddve belt worn.
9. Blades impropedy installed.
10.Improper blades used.
11.Clogged mower deck vent
holes from buildup of gross,
leaves, and trash around
mandrels.
1, Switch is "OFF".
2, Bulb(s) burned out.
3, Faulty light switch.
4, Loose or damaged widng.
5, Blown fuse.
1. Bad battery cell(s).
2, Poor cable connections.
1. Place throttle control in
"FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before
mowing.
4, Level mower deck.
5. Check tires for proper air
pressure.
6. Replace/sharpen blade.
Tighten blade bolt.
7. Clean underside of mower
housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge
down.
10. Replace with blades listed
in this manual.
11.Clean around mandrels to
open vent holes.
1. Turn switch "ON".
2. Replace bulb(s).
3. Check/replace light switch.
4. Check widng and connec-
tions.
5. Replace fuse,
1. Replace battery.
2. Check/clean all connec-
tions.
3. Replace regulator.3, Faulty regulator
(if so equipped).
4. Faulty alternator. 4. Replace alternator.
Engine "backfires" 1. Engine throttle control not 1. Move throttle control to
_vhenturning set at "SLOW" position "SLOW" position and allow
sngine"OFF" for 30 seconds before to idle for 30 seconds before
stopping engine, stopping engine.
32
Loading ...
Loading ...
Loading ...