Loading ...
Loading ...
Loading ...
KiP°NU!
Terminal _ ;__-_1_ I_ He×
Door----_.'_ _*_----_ Positive
. - <Rod>
Terminal_ | _ Cable
Guard _-| l_Negative (Black)
':'__ J" Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3, Reptace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged widng may cause your
tractor to run poorly, atop running, or
prevent itfrom starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO ADJUST ATTACHMENT LIFT
SPRING
1. While holding spdng bushing with
wrench, loosen jam nut.
• Turn adjustment bolt clockwise to
extend spring and reduce lifteffort for
heavier attachments.
• Turn adjustment bolt counterclockwise
for lighter attachments.
2. Retighten jam nut against spdng
bushing.
IMPORTANT: Do not adjust for maximum
spdng tension when using light attach-
ments such as a mower. Adjust lift lever
spring to aid in lifting attachment. Do not
overpower spring. When removing
attachment, always adjust spring tension
to its lowest position.
/_ Adjustment Bolt
ng Bushing
_fi F JatmN.t "AttachmentLift
|ll/ /,_ aam Nu( _ Spring
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2, Unsnap headlight wire connector,
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and liftoff of
tractor,
4. To replace, reverse above procedure.
HeadlightWire
,
ENGINE
Maintenance, repair, or replacement of
the emission controt devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-read engine repair ectablish-
ment or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be
necessary. Check adjustment as de-
scdbed below before loosening cable. If
adlustment is necessary, proceed as
follows:
1. With engine not running, move throttle
control lever to fast position.
2. Check that speed control lever is
against stop screw. If it is not, loosen
casing clamp screw and pull throttle
cable until lever is against screw.
Tighten clamp screw securely.
tdle Fuel Adjusting Idlespeed Adjusting
Throttle
Control
Cable
Choke
Control
Cable
27 Scre_lamp
Loading ...
Loading ...
Loading ...