Loading ...
Loading ...
15.Usescrewremovedinstep3fromplasticmountingbracket
tomountH-tapon new harness to module and snap module
cover and harness assembly onto ice maker. Besure to keep
the harness in the channel. See Figure 13.
19. Lay auger on aflat surface and snap new impinger in place
(impinger tabs should face auger yoke assembly as shown),
See Figure 17.
FIGURE!3
16. Connect module connector to icemaker module.
See Figure !4.
FIGURE14
FIGURE17
20. With auger head on flat surface, install new ice maker
assembly onto top side of impinger. Squeeze impinger
and ice maker assembly together aligning holes on bottom
of impinger with mounting holes on bottom of ice maker
assembly. Install 3 screws provided with kit, See Figure 18.
17. Slide thermal fuse into clip on ice maker. See Figure 15.
FIGURE15
FIGURE18
21. Turn assembly upright and reconnect ice maker harness.
See Figure 19.
Installing New Ice Maker and Impinger
18. Cut tab off new impinger. See Figure 16.
FIGURE16
FIGURE19
(continued)
W10477229B -- 3 --
Loading ...