Loading ...
7. Disconnect harness, push in middle tab, See Figure 5, 11, Remove icemaker from impinger assembly, See Figure 9,
FIGURE5
8, Release tab on left front of ice maker and slide ice maker
module forward. See Figure 6,
FIGURE6
FIGURE9
12. Removeimpingerfrom auger head and discard old impinger,
keep auger head. See Figure 10.
9, Set ice maker module upright and disconnect ice maker to
auger wire harness. See Figure 7.
FIGURE7
10. Turn ice maker module over and remove three screws from
bottom of impinger to release ice maker, Discard screws,
See Figure 8.
FIGURE10
Assembling New Ice Maker
13, Instal] new switch into new module cover, See Figure 11.
FIGURE11
t4. Install connectors to switch and route new harness in module
cover behind tabs and in channel as shown. See Figure 12.
NOTE: Swit6h connector orientation does not matter.
FIGURE12
FtGURE8 (continued)
2 W10477229B
Loading ...
Loading ...