Loading ...
Loading ...
Loading ...
3.Ifthedesiredangleisoneoftheninepositive
stops,releasethepositivestoplockinglever,
makingsuretheleversnapsintoposition,and
thensecurebytighteningthemiterhandle.
4.Ifthemiterangledesiredisnotoneofthe
ninepositivestops,simplylockthemitertable
intopositionbyturningthemiterhandleinthe
clockwisedirection.
Fig.Q
SETTINGCUTTINGDEPTH(FIG.S)
Thedepthofcutcanbepresetforevenand
repetitiveshallowcuts.
1.Adjustthecuttingheaddown(SeeCUTTING
HEADsection)untiltheteethofthebladeare
atthedesireddepth.
2.Whileholdingtheupperarminthatposition,
turnthestopknob(1)untilittouchesthestop
plate(2).
3.Recheckthebladedepthbymovingthe
cuttingheadfronttobackthroughthefull
motionofatypicalcutalongthecontrolarm.
MITERSCALEINDICATORADJUSTMENT
(FIG,Q}
1.Movethetabletothe0°positivestop.
2.Loosenthescrew(4)thatholdstheindicator
withaPhillipsscrewdriver.
3.Adjusttheindicator(3)tothe0°markand
retightenscrew.
ADJUSTINGFENCESQUARENESS(FIG.R)
1.Loosenthethreefencelockingbolts(1).
2.Lowerthecuttingarmandlockinposition.
3.Usingasquare(3),laytheheelofthesquare
againstthebladeandtheruleragainstthe
fence(2)asshown.
4.Adjustthefence90°tothebladeandtighten
thefourfencelockingbolts.
CAUTION:Ifthesawhasnotbeenused
recently,recheckbladesquarenesstothe
fenceand readjust if needed.
5. After fence has been aligned, using a scrap
piece of wood, make a cut at 90°then
check squareness on the piece. Readjust if
necessary.
Fig. R
1 2 1
....._t_._s_
2
ADJUSTING CUTTING DEPTH (FIG. S)
The maximum depth travel of the cutting head
was set at the factory. Check to see that the
blade does not extend more than 1/4 in. below
the table insert, and does not touch the control
arm throat or any part of the base or table. If the
maximum depth needs readjusting:
1. Loosen the stop knob (1) while moving the
cutting head down until the blade extends just
1/4 in. below the table insert.
2. Adjust the stop knob (1) to touch the stop
plate (2).
3. Recheck the blade depth by moving the
cutting head front to back through the full
motion of a cut along the control arm. If the
blade touches the inside of the control arm,
readjust the setting.
SLIDING THE REAR EXTENSION SUPPORT
BAR (FIG. T)
IA,WARNING
To avoid possible personal injury or damage
to the miter saw due to tipping, do not
operate the saw without the Rear Extension
Support Bar.
Loosen the two screws (1) and extend the rear
extension support bar (2) by sliding it out to
match position, tighten the two screws.
Loading ...
Loading ...
Loading ...