Loading ...
Loading ...
Loading ...
Toemptythedustbag,squeezethemetalcollar
andremovefromexhaustport.Openzipperon
undersideofbagandemptyintowastecontainer.
NOTE:Checkfrequentlyandemptybagbeforeit
getsfull.
INSTALLINGTHEHOLD-DOWNCLAMP
(FIG.FandG)
1.Placethehold-downclampassembly(1)in
oneofthemountingholes(2),locatedbehind
thefence.
NOTE:Therearenoscrewstosecureclamp.
Theclampwillsecureitselftothebasewhen
turningtheknob(3)toclamptheworkpiece.
Donotuseyourotherhandtoholdtheclamp
whentightening.Onlyturnknob(3)tosecure
clamptotable.Theclampwilltiltatanangle
andsecureitselfwhentightened.
Fig.F
<
1. Loosen the miter handle (1). Lift up the
positive stop locking lever (2) and position
the table to left 15°. Release the positive stop
locking lever and lock the miter handle.
2. The sliding fence (3) must be extended to the
left.
3. To remove, loosen and remove the six screws
(4) on the table inserts (5) with a Phillips
screwdriver and remove the insert.
4. To install, reposition the table insert, install
the six screws and tighten.
5. Check for blade clearance by moving the slide
carriage through the full motion of the blade in
the table slot.
4
Fig.H _ J
1 2
MOUNTING THE MITER SAW (FIG. I, J)
FigoG
REMOVING AND INSTALLING THE TABLE
INSERT (FIG. H)
,& WARNINGt
To avoid injury:
• Always unplug the saw to avoid accidental
starting. Remove all small pieces of material
from the table cavity before performing any
cuts. The table insert may be removed for this
purpose, but always reattach the table insert
prior to performing a cutting operation.
• Do not start the sliding compound miter saw
without checking for interference between the
blade and table insert. Damage could result
to the blade, table insert or turntable if blade
I,_ WARNING]
To avoid injury form unexpected saw
movement:
• Disconnect the power cord from the outlet,
and lock the cutting head in the lower
position using the stop latch.
• Lock the slide carriage in place by
tightening the slide carriage lock knob.
• To avoid back injury, lift the saw by using
the designated carrying handles located
on the top of the machine. When lifting,
bend at your knees, not from your back.
• Never carry the miter saw by the power
cord or by the switch handle. Carrying the
tool by the power cord could cause damage
to the insulation or the wire connections
resulting in electric shock or fire.
• To avoid injury from flying debris, do not
allow visitors to stand near the saw during
any cutting operation.
• Support the saw on a level work surface.
• Bolt or clamp the saw to its support.
Mounting instructions
1. For stationary use, place the saw in the
desired location, directly on a workbench
where there is room for handling and proper
support of the workpiece. The base of the saw
has four mounting holes. Bolt the base of the
miter saw (1) to the work surface (5), using
the fastening method as shown in Fig I.
strike occurs during the cutting operation.
13 ;,
Loading ...
Loading ...
Loading ...