Loading ...
Loading ...
Loading ...
For Exterior model
Connect to the water supply line
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler "A" to the tap.
- Every join should be protected with sealing tape.
The water line must be connect-
ed to the cold water pipe. I
If it is connected to the hot
water pipe, it may cause the puri- I
[ tier to malfunction.
COUPLER "A"
If the coupler does no t fit on the curren t tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
TAP
Select the location where the purifier is to install. (Model with the purifier)
- Cut the water line attached to the purifier
to the appropriate place after measuring
the distance between the purifier and the
cold water tap.
LINE
OUTLET
SIDE OF
PURIFIER
I't:l=:l:l:i_[_:i
- If you wish to reassemble the water inlet
and outlet sides of the purifier during purifi-
er installation, see the reference illustra-
tion.
PURIFIER
WATER
WATER INLET SIDE
OF PURIFIER
COUPLER
Remove any residual matter inside the purifier. (Model with the purifier)
- Open the main water tap to check whether water
is running through the water tube on the water
inlet side of the purifier.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
OUTLET SIDE
OF PURIFIER
WATER
PURIFIER
WATER LINE
30
Loading ...
Loading ...
Loading ...