Loading ...
Loading ...
Loading ...
29
Machine information
Specifications
Machine size Depth/Width Height
*
Height (lid open)
Large 650 mm 1020 – 1050 mm 1410 – 1440 mm
Medium 600 mm 1020 – 1050 mm 1360 – 1390 mm
*
Height is measured to the highest point on the console.
Note: exact height of your FabricSmart™ is dependent on how far the feet are inserted into the
base of the machine.
Electrical supply: 220 – 240 V, 50 Hz Sinusoidal, 165 W
Inlet water pressure: Max. 1 Mpa (150 psi), Min. 34 kPa (5 psi)
Standpipe height: 850 – 1200 mm
Sounds and beeps
Your FabricSmart™ washer will make sounds that you will not have
heard from other clothes washers.
Filling
If your clothes washer alternates filling and agitating, and AUTO
SENSING is selected, this means the machine is checking that it
has the right amount of water for the clothes load.
Agitating/draining
The motor will pulse before agitate and while draining before spin.
This may sound like several low thuds. Your machine is checking
there is enough water in the bowl before agitating and that the water has drained before
spinning. During drain your washer will turn the pump off and on about every 10 seconds. This is
to help prevent foreign objects getting caught in the pump.
Beeps
Your washer will beep at the end of the cycle and if you have used Drip Dry or Prewash. If your
machine is beeping continuously or giving a musical series of beeps refer to page 30.
Products that might damage your clothes washer
Concentrated bleaches, nappy sanitisers, some pre-treatment products and hydrocarbon
solvents (eg petrol and paint thinners) can cause damage to the paintwork and components
of your washer. Be careful when washing garments stained with these solvents, as they are
flammable. DO NOT put them in a clothes dryer.
Use of dyes in your washer may cause staining of the plastic components. The dye will not damage
the machine but we suggest you thoroughly clean your washer afterwards including running it
through at least one full cycle. We do not recommend the use of dye strippers in your washer.
Some pre-treatment sprays or liquids can damage your washer’s control panel and plastic
components, so do not use these products on or in close proximity to your washer.
Loading ...
Loading ...
Loading ...