Hardwire Junction Box Installation Instructions
Installation instructions for Model 346-6472
WARNING:
These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products should be
installed in accordance with these instructions, current electrical codes and/or the current National Electric Code (NEC).
WARNING:
Disconnect supply power to the unit prior to installation. Consult a local licensed electrician if you are not sure about the installation.
WARNING: Hardwire junction box is for indoor use (dry location) only.
CONNECTING POWER
1. Ensure that power is disconnected to wiring prior to proceeding.
2. Open cover of the junction box by removing two retaining screws on top of unit. Lid will come loose, but still be
connected to box with wires that go to switch on lid.
3. Locate exposed power wiring exiting from wall.
4. Install the UL Listed flexible conduit clamp (included with the junction box) or similar clamp through the hole in the
back of the junction box.
5. Feed supply wires through this clamp and into the junction box.
6. Tighten clamp’s screws to hold the wired in place.
7. Make sure the mounting surface is mechanically sound and free of obstruction(s). Secure the junction box to the
mounting surface using appropriate fasteners (not included).
8. Make electrical connections matching wire colors (black to black, white to white and green to green/ground) and
secure with wire nuts provided.
9. Ensure that no bare wires are exposed after electrical connections have been made and wire nuts are in place.
10. Arrange the wires inside the box and replace the cover.
11. Tighten retaining screws, being sure that all wires and connections are positioned inside the box and no wires are
pinched between the lid and the box.
12. Turn power on. Fixtures can be added or linked together in two separate runs using the electrical connection ports
on each side of the hardwire junction box.
WARNING! Save these instructions.
1. Do not use in wet locations (for indoor use only).
2. Turn power off before servicing in any way.
3. Properly ground the fixture.
4. Ensure that no bare wires are exposed or visible
outside of the wire nuts/electrical connections.
5. Do not mount over sink or stove.
WARNING! Risk of fire:
Do not exceed 5 amps of total connected load!
SEE REVERSE FOR WARRANTY INFORMATION
©2011 Distributed by Menard, Inc
Eau Clarie, WI 54703 Made in China
Loading ...
