Loading ...
Loading ...
Loading ...
INSTALLING AND ADJUSTING THE D-HANDLE
Model 767r
1. Push the D-handle down onto the shaft housing so
that the handle slants towards the shaft grip (Fig. 1).
The squared bolt hole in the handle is to the right.
2. Insert the shoulder bolt into the squared hole in the
handle. Place the washer on the bolt, and screw the
wing nut onto the bolt. Do not tighten until you make
the handle adjustment,
3. Rotate the D-handle to place the grip above the top
of the shaft housing. Place it a minimum of 6 inches
(15.24 cm) from the end of the shaft grip.
4. While holding the unit in the operating position
(Fig. 2), position the D-handle to the location that
provides you the best gdp.
5. Tighten the wing nut until the D-handle is secure.
On some units, the J-handle may be preinstalled and
only require loosening the screws and adjusting the
J-handle to the operator. Go to step 6 for adjusting the
J-handle if preinstalled.
INSTALLING AND ADJUSTING THE J-HANDLE
Model 767rj, 775r
Installing
1. Remove the screws, nuts, top and middle clamp
pieces that were installed on the J-handle for
shipping.
2. Place the J-handle between the top and middle
clamp pieces (Fig. 3),
J-Handle
ShaftGrip D-Handle
Hous_
___./S/_ Tighten
Bolt _(_ _Washer
...... Fig. 1
Top Clamp
MiddleClamp
Bottom Clamp _ _I
Nuts --_-"
Fig. 3
3. While holding the three pieces together, install the
four (4) screws through the top clamp and into
middle clamp.
NOTE: The holes in the top and middle clamp will line up
only when assembled correctly.
4. Place the clamps and J-handle the over the shaft
housing and onto the bottom clamp.
5. Hold each hex nut in the bottom clamp recess with a
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
Adjusting
6. Loosen the screws so that the J-handle can be easily
moved in the clamp assembly. Do not remove the
screws or nuts.
7. Slide the J-handle in or out until the arrow/white line
on the decal touches the clamp assembly (Fig. 4).
8. While holding the unit in the operating position
(Fig. 5), position the J-handle to the location
that provides you the best grip.
9. Tighten the clamp screws evenly, until the J-handle
is secure.
8
Loading ...
Loading ...
Loading ...