Loading ...
Loading ...
Loading ...
STARTING INSTRUCTIONS
I,_ ARNING" Operate this unit only in a well
ventilated area outdoors. Carbon monoxide
exhaust fumes can be lethal in a confined
area.
WARNING; Avoid accidental starting. Be in
the starting position when pulling the starter
rope (Fig. 11). The operator and unit must be
in a stable position while starting to avoid
serious personal injury.
Avoid serious personal injury, ensure any
Add-On being used is installed correctly
and secure before starting unit.
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Oil and Fuel Mixing Instructions Pg. 10.
2. Put the On/Off Stop Control in the ON (I) position
(Fig. 9).
3. Fully press and release primer bulb slowly 5 to 7
times. Fuel should be visible in the bulb (Fig. 10).
If fuel is not visible, press three (3) more times, or
until it is.
4.
5.
Place the choke lever in the FULL choke (A) H
position (Fig. 10).
With the unit in the starting position (Fig, 11),
squeeze the throttle control to the wide open
(full throttle) position and pull the starter rope briskly
5 times in the FULL choke (A) I"_ position. If the
engine attempts to run before the fifth pull, proceed
to step 6.
NOTE: The engine will not run in the FULL choke (A)H
position.
6. Place the choke lever inthe PARTIAL choke (B) l%.J
position (Fig. 10).
7. Pull starter rope briskly 1 to 3 times to start the
engine (Fig. 11).
NOTE: Squeeze the throttle control until the engine has
started and warmed up.
8. If the engine does not start, repeat steps
4 through 7.
NOTE: If the engine floods while trying to start, place the
choke lever in the RUN (C) I')I position (Fig. 10).
Squeeze the throttle control. Pull the starter rope
briskly. The engine should start within three (3) to
eight (8) pulls.
9. Squeeze the throttle control to warm up engine for 5
to 10 seconds. Place the choke lever in the RUN (C)
I_1position (Fig. 10).
NOTE: Choking isunnecessary when starting a warm
engine. Put the On/Off Stop Control in the ON
_osition (Fig. 9), and start in PARTIAL choke (B)
_1position (Fig. 10).
Stop/Off (O)
Start/On (I)
On/Off Stop Control
= Fig, 9 .........
Partial Choke
FullChoke Position(B) Run
Position(A) | Position (C)
J
-- Choke Lever
-- Primer Bulb
Fig, 10 ................
Starter Rope
Throttle Control
....... Fig. 11
STOPPING INSTRUCTIONS
1. Release your hand from the throttle control (Fig. 11).
Allow the engine to cool down by idling.
2. Put the On/Off Stop Control in the OFF (O) position
(Fig. 9).
11
Loading ...
Loading ...
Loading ...