Loading ...
Loading ...
Loading ...
9
Installation Instructions
4. Carefully put the chimney over the top of the duct
work extending out of the top of the hood, taking care
not to scratch the surfaces. Make sure the wiring is
tucked in behind the chimney.
5. Move the chimney up toward the ceiling. Line up the
holes on the side of the chimney, above the vents,
with the holes on the side of the chimney mounting
bracket.
6. Attach the sides of the chimney to the bracket using
two sheet metal screws, one on each side.
7. Carefully, slide the bottom portion of the chimney
down until it rests on the top of the range hood.
Verifying Proper Operation
1. Reinstall the range hood filter(s) before operation.
2. Make sure power is switched on at the circuit breaker
panel or fuse box.
3. If the control panel is not lit, remove the filter(s) and
turn on the main power switch located behind the
filters on the underside of the hood. Replace the
filter(s).
4. Touch the light key. Verify that all the lights come on.
5. Touch the light key again to turn the lights off.
6. Touch the blower “+” key once and release. Verify
that one light is showing on the blower speed indica-
tor and that the blower is on at low speed.
7. Touch and release the blower “+” repeatedly, three
times. Verify that with each touch of the key the num-
ber of lights on the speed indicator increases and that
the blower speed increases accordingly.
8. Touch and hold the blower “-” key until the blower
turns off.
If the hood fails to operate properly:
■ Verify that power is supplied to the hood.
■ Check the electrical connections to ensure that the
installation has been completed correctly.
■ Repeat the above test.
■ If the hood still does not work, contact Dacor
Distinctive Service at (800) 793-0093 ex. 2822. Do
not attempt to repair the appliance yourself. If you
need service, be sure to have the model and serial
numbers available when you call. See the inside
cover for location.
Do not attempt to repair the appliance yourself. Dacor
is not responsible for the cost of correcting problems
caused by a faulty installation.
Installation Checklist
WARNING
• To ensure a safe and proper installation, the follow-
ing checklist should be completed by the installer
to ensure that no part of the installation has been
overlooked.
• Proper installation is the responsibility of the home-
owner. The importance of proper installation of your
Dacor range hood cannot be overemphasized.
□ Is the mounting bracket properly attached to the wall
according to the instructions on page 6?
□ Is the duct work completely installed? Are all joints
attached with sheet metal screws and wrapped with
duct tape? See pages 4 and 8?
□ Is the range hood wired and grounded according to
these instructions and in accordance with all appli-
cable electrical codes? See pages 3 and 8.
□ Are the filters properly installed according to the use
and care manual?
□ Has proper operation been verified?
□ Has the warranty been activated on-line or the war-
ranty card filled out completely and mailed?
Loading ...
Loading ...
Loading ...