Loading ...
Loading ...
Loading ...
19
WARNING
To avoid risk of injury, always use caution when opening the door
during or following a wash cycle as hot water or steam may escape.
Do not fully open the door until water noises have stopped and steam
has subsided.
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first,
then the upper one (see the section entitled "Loading the
Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
You must have:120-volt,60Hz,AC-only,10-or 12-amp,fused electrical
supply.
Make sure that the water supply is turned on to full pressure. Open
the door, press the "Power“ button, Press the "Program" button to
select a desired "Wash cycle". (See the section entitled "Wash Cycle
Table" ). Press the Start/Pause button and close the door within 4
seconds and the dishwasher will be activated. If the door is not
closed within 4 seconds after pressing the Start/Pause button, the
power is off. In this state, the door is closed and the dishwasher will
not start. Press the Start/Pause button again, the Digital Display
indicator lights up, and the door is closed within 4 seconds. The
dishwasher will be activated.
NOTE: Buttons are sensitive and should be touched gently. Avoid any
grease or food particles resting on the buttons as they could activate
the dishwasher. Wiping and cleaning can also activate the
dishwasher. For best results, use bare, clean hands when touching
the buttons.
OPERATING THE DISHWASHER
OPERATING THE DISHWASHER
Program
Normal
Rinse
Wash
Dry
Express
Water
Supply
Heavy
Delicate
Light
12
Start/Pause
Delay
Add Rinse Aid
Add Salt
8
7
9
6
4 3
5
1.ON/OFF Button: To turn on/off the power supply.
2.Program select button: Press the button to select the washing
program.
3.Program indicator light: when you select a washing program, the
corresponding light will display.
4.Drying light: To come on when the dishwasher is drying.
5.Washing/Inlet water abnormal status indicator: When the machine
is washing, the “Wash” indicator is on. When the machine Inlet water
abnormal in the water inlet stage, the “Water Supply” indicator.
Flashing lights up.
6.Salt and rinse aid indicator light: To come on when the softener or
dispenser needs to be filled.
7.Start/pause button: The appliance will start or pause the expected
washing cycle.
8.Delay button: The START DELAY will allow you to delay the start
time of any cycle automatically up to 24hours.
9.Digital display: To display the running time remain, malfunction
codes and delay time.
Loading ...
Loading ...
Loading ...