Loading ...
Loading ...
Loading ...
BUTTONS d s:
Align two holes of button with slot of presser foot and
lower foot to hold button securely. Drop feed dog.
Turn hand wheel by hand until needle point is just
above button. Adjust stitch width so that needle will
align with a hole of button. Turn hand wheel again by
hand so that needle goes into second hole, readjust
stitch width if necessary. Stitch a number of times,
turning hand wheel manually. Finish with an extra 2
inches of thread, draw thread to reverse side and tie
securely.
If using a 4 hole button repeat the above procedure.
NOTE : To make a small thread shank when sewing
on a flat button, place a straight pin or needle
between the holes of the button.
STRAIGHTORTHREE-CORNEREDTEAR
Stitch width 3 - 4
Stitch length at red mark
Pattern disc #4A (Model 16, 1749, 542)
# 1A (Model 540,541 )
Position tear under needle and stitch along the straight
tear catching sides of material. When mending a three
cornered tear, stitch from each end to center.
23
Loading ...
Loading ...
Loading ...