Loading ...
Loading ...
Loading ...
8
31-1000190 Rev. 0
STEP 2 REMOVE UPPER
ENCLOSURE (Cont.)
Ŷ/RFDWHEOXHDUURZRQ¿OWHU5RWDWH¿OWHUWRDOLJQDUURZ
as shown.
Ŷ,QVHUW¿OWHULQWRSRVLWLRQDQGURWDWH
óWXUQFORFNZLVHXVH¿OWHUUHPRYDO
tool if needed).
Ŷ5HWXUQ¿OWHUUHPRYDOWRROWR
mounting hook.
Ŷ Close the compartment door.
Installation Instructions - Reversing the Door Swing
STEP 3
MOVE CONTROL ASSEMBLY
Ŷ Remove the Phillips head screw from the middle of
the housing on the hinge side.
Ŷ Insert a flat head screwdriver or putty knife between
the glass front and plastic side and free the control
assembly by prying the plastic pins clear of the side
bracket holes.
Ŷ Lay the glass assembly on top of the control housing.
Ŷ Remove 4 screws, 2 on each end, to remove the
housing assembly using a T-20 Torx bit.
Ŷ Move the housing assembly to the opposite side and
install using the 4 screws, 2 on each side.
NOTE: Make sure wires do not get pinched. On 18”
models, the red/white/black 5-pin wire connector
will need to be removed from the control board and
routed through the opposite corner bracket and
reconnected to the control board to prevent pinching
the wiring.
STEP 3
MOVE CONTROL ASSEMBLY
(Cont.)
Ŷ Snap glass assembly back onto the control housing
assembly, ensuring plastic pins snap into holes on
the side of the housing.
STEP 4 MOVE LIGHT SWITCH
HOUSING
Ŷ Remove front access cover from unit by removing
two 1/4” hex head screws.
Ŷ Remove screw with 1/4” hex bit driver at the bottom
middle of light switch housing.
Plastic Pins
(Both sides)
Screw
5-pin wire connector
Wires must be rerouted from one
side to the other for 18” models.
Access Cover
1/4” Hex Head
Screws
Light Switch
Housing
Light
Switch
Loading ...
Loading ...
Loading ...