Loading ...
Loading ...
Loading ...
27
31-1000190 Rev. 0
Installation Instructions - Dual Retro-Fit Installation
STEP 3 PREPARING UNIT FOR
INSTALLATION
Ŷ Place the right hand unit in front of the installation
opening in a way that the unit is in front of the
intended installed location.
Ŷ Unpack the heater Unification Kit (ZKUN) and make
sure all of the components on the list are included.
Ŷ
Install adhesive heater on the outside of the unit to
the left side of the case. Install heater 4” below the
case top. Heater should be centered front to back
on the metal case. Ensure the heater connector cord
is towards the bottom of the top of the unit when
installed.
STEP 2 INSTALL WATER LINE
(Cont.)
Ŷ Tubing should be long enough to extend to the front
of the unit. Allow enough tubing to accommodate
bend leading into the water line connection. Unit must
be tipped on its side to route waterline underneath
and to the front of the appliance.
NOTE: The only GE Appliances approved plastic tubing
is supplied in the SmartConnect
™
Refrigerator Tubing
kits. Do not use any other plastic water supply line
because the line is under pressure at all times. Other
types of plastic may crack or rupture with age and
cause water damage to your home.
Ŷ Tape the jumper waterline and water fitting tee to the
back wall. The waterlines will be taped to the floor
using masking tape after anti-tip bracket installation.
STEP 3 PREPARING UNIT FOR
INSTALLATION (Cont.)
Ŷ Install the transformer into the case top assembly:
1. Remove cover top by removing eight #8 hex screws
and keep aside for assembling back the cover top.
2. Place the transformer into the case top provided in
ZKUN kit and secure it with the existing (1/4”) hex
screws to left front of case top.
3. Connect the 2 pin transformer connector to the
heater connector and 3 pin connector to panel
control, make sure locking tabs are engaged.
4. Verify the master switch is on.
5. Assemble the cover top with screws save from
previous step.
6. Enclosure assembly upper is hidden for clarity.
WARNING
Electrical Shock
Hazard. To avoid the risk of electric shock, make
sure the power cord is not plugged into the wall
outlet.
Clips
2 Pin
Connector
to Heater
Connector
3 Pin
Connector
Transformer
Master Switch
#8 Hex Screws
Cover Top
Loading ...
Loading ...
Loading ...