Loading ...
Loading ...
Loading ...
53
31-1000190 Rev. 0
STEP 2 INSTALL OVERLAY PANEL
Ŷ Remove bottom hinge cover and retain the 4 T30
Torx screws for later installation.
Ŷ Open door to 90°. Slide the
panel onto the door with the
panel brackets interlocking
on top and bottom with the
door brackets (make sure
not to slide the panel into
the cabinetry surround).
Center the panel on the
door, then slowly close the
door while watching to make
sure the panel does not contact
the surrounding cabinetry.
Ŷ With the door fully closed,
carefully slide the panel towards
the cabinetry with the goal gap
of 1/8”.
STEP 3 ADJUST OVERLAY PANEL
(Cont.)
Ŷ Follow the next steps for set screw installation.
Ŷ For flush mounting, inspect the gap between the
panel and cabinetry at the handle side.
¿ If the vertical gap between the
cabinetry is smaller at the top
than the bottom, insert and drive
the vertical screw on the top
bracket near the hinge side until
the gap is equal along the entire
vertical section. (You may need to
slide the panel to realign the side
gap to 1/8”.)
¿ If the vertical gap between the
cabinetry is larger at the top than the
bottom, insert and drive the vertical
screw on the top bracket near the
handle side until the gap is equal
along the entire vertical section.
(You may need to slide the panel to
realign the side gap to 1/8”.)
Ŷ Inspect the alignment at the top of the panel.
Adjustments can be made by turning the vertical
adjustment screws, equally, on the top of the panel
bracket (2 adjustment screws per panel).
Ŷ If the panels do not lay flat, they can be adjusted.
Start by adjusting the top corners and then moving
to the bottom corners. Each corner can be adjusted
independently.
¿ If the panel is too deep inside the
cabinetry, the panel needs to move
away from the unit. Install the
outermost horizontal screws in all 4
corners and screw in until panel is
in position.
¿ If the panel is too proud of the
surrounding cabinetry, the panel
needs to move toward the unit.
Install the innermost horizontal
screws in all 4 corners and screw in
place until the panel is in position.
STEP 3 ADJUST OVERLAY PANEL
Ŷ Door adjustments will
be made with 12 set
screws provided. Each
corner of the door will
use 3 adjustment set
screws. Use a 1/8” allen
wrench to install the set
screws in the order as
instructed.
Ŷ The set screws behind
the top and bottom
support brackets are
partially hidden.
Installation Instructions - Custom Overlay Door Panel
Door
Bracket
Panel
Bracket
Panel
Vertical adjustment screw locations.
1/8” gap
Cabintery
Surround
Overlay
Panel
Set
Screws
Hidden Set
Screw
Set
Screws
Bottom
Hinge
Cover
T30 Torx
Screws
Loading ...
Loading ...
Loading ...