Loading ...
Loading ...
Loading ...
EN
27
Cleaning and Maintenance
www.bora.com
8.3.1 Cleaning of the gas burners
1
2
3
4
5
6
Fig. 8.1 Gas burner installation
[1] Burner cover
[2] Burner head
[3] Safety thermocouple
[4] Electrical ignition device
[5] Burner housing
Do not clean the device until the gas burner has cooled
down to normal temperature after use.
Clean the device only with normal hot rinse water and
a commercially available detergent by means of a soft
sponge or a normal dishcloth.
Never scrape or scratch off cooking residues.
Do not put the gas burner parts and the pot holder in
the dishwasher for cleaning.
Remove the pot holder.
Remove the burner cover [1] from the burner head [2].
Remove the burner head [2] from the gas outlet valve
Clean the burner parts.
Put the burner parts back together again after
cleaning.
The burner heads and burner covers must be
completely dry before they are put back in place.
Position the burner head [2] correctly on the gas outlet
valve.
Make sure that the safety thermocouple and the
electrical ignition device are positioned in the correct
opening.
Put the burner cover [1] straightly and evenly on the
burner head [2].
The electrical ignition will not work if burner parts are
not put back in place correctly.
Put the pot holder straightly and evenly on the gas
cooktop.
Put the gas burner into operation (see the Operation
chapter).
8.3.2 Cleaning the control knobs
Ensure that the cooktop is switched off
(see the Operating chapter).
Clean only the control knob by hand.
Pull off the control knob.
Clean the control knob with a soft brush.
Rinse the control knob well after cleaning.
Allow the control knob to dry thoroughly.
Re-insert the clean and dry control knob into the slot
after the cleaning is completed.
Loading ...
Loading ...
Loading ...