Loading ...
Loading ...
Loading ...
EN
17
Installation
www.bora.com
1
3
2
Fig. 5.11 Mounting brackets
[1] Mounting bracket
[2] Washer
[3] Screw
Affix the cooktop using the mounting brackets [1].
Use the screw [3] and the washer [2] to tighten the
mounting brackets with max. 10 Nm.
Check that the cooktop is positioned correctly.
Once all of the installation work is complete, seal the
devices with black, heat-resistant silicone sealant.
5.6 Power connection
Observe all safety and warning information in the
Safety section.
Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO The power connection may only be established
by a certified specialist. He/she also assumes
responsibility for the proper installation and
commissioning.
The power supply line for use (pre-assembled) must be of
the type H05VV-F or H05VVH2-F as a minimum.
Cross-section: 3G 1.5 mm²
If the connection line has been damaged this must be
replaced by a special connection line. This may only
be done by an authorised member of the After Sales
Service team.
Installing the cooktop
12
Fig. 5.9 Installed cooktop with cooktop extractor
[1] Cooktop
[2] Cooktop extractor
Insert the cooktop [1] next to the cooktop extractor [2]
that has already been installed in the centre.
INFO The cooktop [1] lies on the side rail of the cooktop
extractor [2], which stabilises it.
Precisely position the cooktop [1].
If necessary, use the height adjustment plates to
adjust the cooktop’s installation height.
1
2
Fig. 5.10 Cooktop and height adjustment plates
[1] Cooktop
[2] Height adjustment plates
For surface mounting
Make sure that the sealing tape for the cooktop is flat
against the worktop.
For flush installation
Make sure that the sealing tape of the cooktop is
sealed well all the way round.
Loading ...
Loading ...
Loading ...