Loading ...
Loading ...
16
EN
Instructions for use
Installation
All the operations concerned with
the installation (electrical and gas
connections, adaptation to type of gas,
necessary adjustments, etc.) must be
carried out by qualied technicians, in
terms with the standards in force.
For specic instructions, kindly read
the part reserved for the installation
technician.
Use
Gas burners (Fig. 1-3).
The ignition of the gas burner is carried
out by putting a small ame to the upper
part holes of the burner, pressing and
rotating the corresponding knob in an
anti-clockwise manner, until the maxi-
mum position has coincided with the
marker. When the gas burner has been
turned on, adjust the ame according to
need. The minimum position is found at
the end of the anti- clockwise rotation
direction.
In models with automatic ignition,
operate the knob as described above,
pressing simultaneously, the cor-
responding push-button. For models
with automatic/ simultaneous (with
one hand) ignition, it is sucient to
proceed as described above using
the corresponding knob. The electric
spark between the ignition plug and
the burner provides the ignition of the
burner itself. After ignition, immediately
release the push-button and adjust the
ame according to need.
For models with a thermoelectric safety
system, the burner is ignited as in
the various cases described above,
keeping the knob fully pressed on the
maximum position for approximately
3/5 seconds. After releasing the knob,
make sure the burner is actually lit.
N.B. - we recommend the use of pots
and pans with a diameter matching that
of the burner, thus preventing the ame
from escaping from the bottom part and
surrounding the pot
• do not leave any empty pots or pans
on the re
• do not use any tools for grill-cooking
on Crystal hobs.
When cooking is nished, it is also a
good norm to close the main gas pipe
tap and/ or cylinder.
Models with Dual Wok burner
Some models have a Dual Wok
burner. The centre ame (F1) can be
lit by pressing the knob and turning it
clockwise or the entire burner (F2) can
be lit as shown the gure below.
Loading ...
Loading ...
Loading ...