Loading ...
Loading ...
Loading ...
77
3. DISHWASHER CONNECTION PREPARATION
CONNECTION
If you are utilizing a dishwasher, complete the
following procedure.
Using a blunt instrument (steel punch or wooden dowel),
knock out entire plug. Do not use a screwdriver or sharp
instrument. (When knockout plug falls into disposer, you may
remove it or grind it up when the disposer is used. This will
not damage the disposer in any way, but it may take some
time to grind).
4. LOCKING MOUNTING ASSEMBLY DETAIL
Attach disposer onto the Upper Mount Ring by aligning
the three mount tabs on the Lower Mount Ring with the
slide-up Ramps on the Upper Mount Ring and rotating
counterclockwise. See Below.
The Lower Mount Ring (which is part of the disposer) has 3
tabs that grab the mounting ring ramp.
(A) points to the Upper Mount Ring.
(B) is the tab that slides up onto the “Ramp”.
(C) is the “Ear” that is used to help rotate the Lower
Mount Ring.
Use a screwdriver for leverage if needed.
Lift and turn the Lower Mount Ring counterclockwise until
all three mount tabs lock over the Ridges (F) on the slide-up
Ramps (D) of the Upper Mount Ring.
As the Lower Mount Ring is turned counterclockwise each tab
slides up onto the Upper Mount Ring Ramp (E) and locks in
position over the Ridges (F).
Use a screwdriver or hammer for leverage if needed.
If a disposer needs to be removed, tapping on the Ear clockwise
with a hammer will easily loosen the Lower
Mount Ring.
5. DISCHARGE ELBOW &
DISHWASHER CONNECTIONS
A. Connect the waste elbow to the disposer by sliding
the fl ange against the rubber gasket on the elbow and
tightening the screws into the disposer (see 5A). Then
connect bottom of the elbow by tightening the slip
nut (see 5B). If using a straight pipe, it must have a lip
similar to the one on the elbow. Remove the gasket
from the elbow and install it on the straight pipe with
the fl at end of the gasket facing toward the disposer
discharge opening. IF YOU ARE NOT CONNECTING TO
A DISHWASHER make sure all plumbing connections
are tight and in accordance with all plumbing codes and
ordinances. Run water and check for leaks. Go on to
Step 6.
KNOCK OUT
PLUG
WOOD OR
METAL DOWEL
Loading ...
Loading ...
Loading ...