Loading ...
Loading ...
Loading ...
12
CLEANING AND MAINTENANCE
DO NOT ATTEMPT TO LUBRICATE
YOUR DISPOSER!
The motor is permanently lubricated. The disposer is self cleaning
and scours its internal parts with each use. NEVER put lye or
chemical drain cleaners into the disposer, as they cause serious
corrosion of metal parts. If used, resulting damage can be easily
detected and all warranties are void. Mineral deposits from
your water can form on the stainless steel turntable, giving the
appearance of rust. DO NOT BE ALARMED, the stainless steel
turntables used will not corrode.
Having Problems? Don't go back to the store.
Call us toll-free at 1-833-240-6224 for assistance.
M-F 8:00am-5:00pm PST English & Spanish
TROUBLESHOOTING
Before seeking repair or replacement, we recommend that you
review the following:
LOUD NOISES: (Other than those during grinding of small
bones and fruit pits): These are usually caused by accidental
entry of a spoon, bottle cap or other foreign object. To correct
this, turn o electrical switch and water. After disposer has
stopped, remove splash guard, remove object with long handled
tongs, and replace splash guard.
UNIT DOES NOT START: Unplug power cord or turn either the
wall switch or breaker box switch to “OFF” position, depending
on your model and wiring confi guration. Remove stopper and/or
splash guard. Check to see if turntable will rotate freely using a
wooden broom handle. If turntable rotates freely, replace splash
guard and check reset button to see if it has been tripped. Reset
button is red and located on the front of the disposer. Push
button in until it clicks and remains depressed.
If reset button has not been tripped, check for shorted or
broken wire connecting to disposer. Check electrical power
switch, fuse box or circuit breaker. If wiring and electrical
components are intact, the unit may have internal problems that
require service or replacement.
IF TURNTABLE DOES NOT ROTATE FREELY: Turn o disposer,
then check for any foreign object lodged between the turntable
and grind ring. Dislodge object by rotating table with a wooden
broom handle (see 8A) and remove object. If no foreign object
is present, there may be internal problems.
LEAKS: If the unit leaks at the top, it may be due to:
1. Improper seating of sink fl ange (gasket centering, putty
or tightening).
2. Support fl ange not tightened properly.
3. Defective or improperly installed cushion mount.
If unit leaks at the waste elbow, leak may be due to improper
tightening of elbow fl ange screws.
8A
Loading ...
Loading ...
Loading ...