Loading ...
Loading ...
Loading ...
29
4. Switch off the appliance after operation as described in this instruction manual.
5. Do not put any heavy items on the hob.
6. Only use cookware which is suitable to be used on a ceramic hob; otherwise you
will damage the glass ceramic.
7. The blades of scrapers for cleaning a ceramic hob are very sharp. Do not cut
yourself, especially when you have removed the safety cover of the scraper.
8. If any cracks occur on the glass-ceramic , switch off the appliance and disconnect
it from the mains. Risk of electrical shock!
9. This appliance is designed for the use by adults only.
10. The appliance is not intended for commercial purposes.
11. Do not use the appliance for camping.
12. Do not use the appliance in public transport.
13. The appliance is designed for indoor use only.
14. This appliance complies with the current European safety legislation. We do wish
to emphasize that this compliance does not negate the fact that the surfaces of
the appliance will become hot while operating and will retain and emit heat
even if it has stopped operating.
4. INSTALLATION
WARNING!
All electrical connections which may be damaged must be repaired by a
qualified professional. All repairs should be performed by your
authorized after sales service.
Unpacking and positioning
1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
3. Check that the appliance and the power cord are not damaged.
4. Connect the appliance to a dedicated socket only.
5. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
Installation / hob
A. Selection of installation equipment
Cut out the installation hole as described on the drawing below. For installation and
use, a minimum of 50mm space shall be preserved around the hole. The thickness
of the work top should be at least 30 mm. Choose heat-resistant materials for the
Loading ...
Loading ...
Loading ...