Loading ...
Loading ...
Loading ...
en Troubleshooting
50
Fault Cause and troubleshooting
Excessive formation of
foam occurs.
Hand washing-up liquid is present in dispenser for
rinse aid.
▶ Immediately add rinse aid to the dispenser.
→"Adding rinse aid", Page30
Rinse aid has been spilled.
▶ Remove the rinse aid with a cloth.
Detergent or appliance care product used causes ex-
cessive foaming.
▶ Change the brand of detergent.
Fault Cause and troubleshooting
Special salt refill indic-
ator lights up.
Insufficient special salt.
▶
Add Special salt →Page28.
Sensor does not detect special salt tablets.
▶ Do not use special salt tablets.
Refill indicator for spe-
cial salt does not light
up.
Water softening system is switched off.
▶
Setting water softening system →Page28
Refill indicator for
rinse aid lights up.
Insufficient rinse aid.
1.
Add Rinse aid →Page30.
2. Set the amount of rinse aid to be dispensed.
→"Setting the amount of rinse aid", Page30
Refill indicator for
rinse aid does not
light up.
Rinse aid system is switched off.
▶
→"Setting the amount of rinse aid", Page30
Fault Cause and troubleshooting
Water is left in the ap-
pliance at the end of
the programme.
Filter system or area under the filters is blocked.
1.
Clean the Filters →Page40.
2.
Clean the Wastewater pump →Page53.
Programme has not yet ended.
▶ Wait until the programme ends or cancel the pro-
gramme with reset.
▶
→"Terminate programme", Page37
Appliance cannot be
switched on or oper-
ated.
Appliance functions have failed.
1. Pull out the mains plug or switch off the fuse.
2. Wait at least 2minutes.
3. Connect the appliance to the power supply.
4. Switch the appliance on.
Loading ...
Loading ...
Loading ...