Loading ...
Loading ...
Loading ...
Troubleshooting en
47
Fault Cause and troubleshooting
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent →Page31.
▶ Clean the appliance mechanically.
White coating is deposited in the appliance interior.
1. Set the water softening system correctly.
In most cases you will need to increase the setting.
2. Change your detergent if required.
Special salt dispenser is not screwed tight.
▶ Screw the special salt dispenser tight.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent →Page31.
▶ Clean the appliance mechanically.
The hardness range is set incorrectly or the water
hardness is greater than 44°E (6,2mmol/l).
▶
Set the Water softening system →Page27 to the
water hardness or add special salt.
3in1/organic/eco detergent is not effective enough.
▶
Set the Water softening system →Page27 to the
water hardness and use separate detergents (pro-
prietary detergent, special salt, rinse aid).
Too little detergent is being used.
▶ Increase the amount of detergent used or change
Detergent →Page31.
Washing programme selected too weak.
▶ Select a more intensive washing programme.
▶ Adjust the sensitivity of the sensors.
Tea residue or lipstick
marks on tableware.
Washing temperature is too low.
▶ Select a programme with a higher washing temper-
ature.
Too little detergent is being used or is unsuitable.
▶
Use a suitable Detergent →Page31 and follow the
manufacturer's instructions for the amount to be
used.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶ Only remove large remnants of food and do not
prerinse tableware.
Loading ...
Loading ...
Loading ...