Loading ...
Loading ...
Loading ...
GB
8
ELECTRICAL SUPPLY
The manufacturer can not be held responsible for any damages to persons or objects
caused by failure to observe these instructions.
Before installing the oven have a qualified electrician verify that your home is provided
with adequate electrical service and that the addition of the oven will not overload the
circuit on which it is to be installed A separate three-wire single phase 240V or 220-
240V 50/60 Hz circuit is required If the supply cord is damaged.
it must be replaced by the manufacturer its service agent or similarly qualified persons
in order to avoid a hazard
!!WARNING!!
ELECTRICAL SHOCK HAZARD
• The electrical power to the oven circuit must be shut off while
line connections are being made
• Do not use an extension cord with this appliance
• Electrical ground is required on this appliance
The free end of the yellow/green wire (the ground wire) must be
connected to a suitable ground This wire must remain grounded
to the oven
• A qualified electrician must install the appliance
• The oven must be earthed in accordance with the current
Australian Standard
NOTE FOR AUSTRALIA: This appliance must be correctly
installed and serviced by a suitably qualified person, strictly in
accordance with AS/NZS 3000 wiring rules.
• The oven must be connected to the mains through a multipole
circuit breaker with a contact-to-contact gap of a least 3 mm
marking sure that the earth wire is not disconnected.
• Such a device must be fitted to the power supply in compliance
with the regulations governing electrical installations.
• The socket or switch must be easily reachable with the oven
fully installed.
Failure to follow these instructions could result in serious injury
or death
Wiring Requirements
Before making connections make sure the power is off and read and observe the
following:
• A separate three-wire single phase 240V or 220-240V 50/60 Hz circuit is required for
the oven
• The oven must be connected with COPPER WIRE ONLY.
• NOTE FOR AUSTRALIA: the oven must be installed to conform with the current
Australian Standard.
• Wire size (COPPER WIRE ONLY) and connections must be suitable for the rating of
the appliance per the current Australian Standard.
Loading ...
Loading ...
Loading ...