Loading ...
Loading ...
Loading ...
@
High: Use to bring iiquid to a boil or reach
pressure in a pressure cooker. Nways
reduce setting to a bwer heat when iiquids
begin to boii or foods begin to cook.
An intermedbte flame size is used to
continue cooking. Food will not cook any
faster when a higher flame setting is used
than needed to maintain a gentb boE
Water boiis at the same temperature
whether boiiing gently or vigorousiy.
Medium to Low: Use to simmer
foods and keep foods warm. Some
cooking may take piace on the Low
setting if the pan is covered. It is
possiMe to reduce the heat by
rotating the knob toward OFF. Be
sure flame is staMe.
Surface Controls
If flame should go out during a cooking operation, turn
the burnel to OFF, if a strong gas odor is detected, open
a window and wait five minutes before relighting the
burnel
o Be sure all surface controb are set in the OFF position
before supplying gas to the range.
- NEVERtouch cooktop until it has cooled. Expect some
parts of the cooktop, especiaii} around the burners, to
become warm or hot during cooking. Use potholders to
PiLotLess ignition
Pilotless ignition eliminates the
need for a constant standing
pilot light. Each surface burner
has a spark ignitor. Use care
when cleaning around the
surface burner.
If the surface burner does
not light, check if ignitor is
damaged, soiled or wet.
BURNER CAP
Ports
gnitor
BURNER BASE
Surface Control Knobs
Use to turn on the surface burners. An infinite choice of heat
settings is available from Low to High. At the High setting a
detent or notch may be fee The knobs can be set on or
between any of the settings.
Graphics next to the knob identify which burner the
knob controls. For example, the graphic at right
shows the left front burner location.
Setting the controms:
The size and type of cookware will affect the heat setting. For
information on cookware and other factors affecting heat
settings, refer to "Cooking Made Simple" booklet.
1. Place a pan on the burner grate.
" The burner flame may lift off or appear separated from
the port if a pan is not placed on the grate.
2. Push in and turn the knob counterclockwise to the Light
setting.
" A clicking (spark} sound will be heard and the burner
will light. (All of the ignitors will spark when any surface
burner knob is turned to the Light position.}
3. After the burner lights, turn knob to desired flame size.
" The ignitor will continue to spark until the knob is
turned past the Light position.
Operating Surface Burners
During a Power FaiLure
When lighting the surface burners, be Sure all o1:the
Controls are in the OFF position, Strike the match first and
hold it in posit!on before turning the knob to Light_
1. Hold a lighted match to the desired surface burner head.
2. Push in and turn the control knob slowly to Light.
3. Adjust the flame to the desired level.
5
Loading ...
Loading ...
Loading ...