Loading ...
Loading ...
Loading ...
10
www.linarie.com.au
6. MAINTENANCE & CLEANING
WARNING
Observe all safety and warning information during operation (see the “General Safety Instructions”
section). Before maintenance or cleaning, the appliance should always be disconnected from the
power supply. Make sure that the appliabce is switched off and the plug has been removed.
Do not rinse directly with water or scrub in water.
Exterior surfaces are prone to scratches and dents. Therefore, please follow the cleaning
instructions to achieve the best possible result without damage.
GENERAL INFORMATION
Allow the appliance to cool down completely before cleaning and maintenance.
Black crystal plate, operation plate cleaning
Slight dirt: wipe with a soft cloth.
Oil fouling: please use a soft cloth with a little neutral detergent, detergent powder or light powder.
Then wipe with a soft wet cloth to leave no residue.
Use cotton swab to remove dust on the surface of air inlet and air outlet.
Refer to cleaning and maintenance reminder in page 4.
Body cleaning:
Wipe with soft dry cloth, dust o ffof air inlet and air outlet, wait for complete air drying and then use.
The surfaces and controls are susceptible to scratches and abrasion. Please observe the
following cleaning instructions.
GENERAL INFORMATION
Allow the appliance to cool down completely before cleaning and maintenance.
The surface and controls are susceptible to scratches and
abrasion. Please observe the following cleaning instructions.
Observe all safety and warning information during operation
(see the “General Safety Instructions” section).
WARNING
If you have completed the above check and still having difficulty, please contact
your local Linarie Service Center. See “Warranty and Spare parts section”.
Before maintenance or cleaning, the appliance should always be disconnected from
the power supply. Make sure that the appliance is switch off and the plug has been
removed. Exterior surfaces are prone to scratches and dents. Therefore, please follow
the cleaning instructions to achieve the best possible result without damage.
Loading ...
Loading ...
Loading ...