Loading ...
Loading ...
Loading ...
8
Important Safety Instructions
Avoid Accidents
To reduce the risk of fire, electrical shock, or injury when using your air conditioner, follow these basic
precautions:
• Ensure that the electrical service is adequate for the model you have. This information can be found
on the rating label, which is located on the side of the cabinet and behind the grille.
• If the air conditioner is to be installed on a window, clean both sides of the glass first. If the window
is a triple track and it has a screen panel included, remove the screen completely before installation.
• Ensure that the air conditioner has been securely and correctly installed according to this manual's
installation instructions. Save this manual for possible future use in case you may need to remove or
reinstall this unit. When handling the air conditioner, be careful to avoid cuts from the sharp metal
fins on the front and rear coils.
Electrical Information
The complete electrical rating of your new air conditioner is stated on the rating label. Refer to the rating
when checking the electrical requirements.
• Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper
grounding is important. The power cord is equipped with a three-prong grounding plug for protection
against shock hazards.
• The air conditioner must be used in a properly grounded wall receptacle. If the wall receptacle you
intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker, have a
qualified electrician install the proper receptacle. Ensure the receptacle is accessible after the unit
installation.
• Do not run the air conditioner without a side protective cover in place. The absence of a side
protective cover could result in mechanical damage within the air conditioner.
• Do not use an extension cord or an adapter plug.
OPERATION OF THE CURRENT DETECTION DEVICE
The power cord contains a current device that senses damage to the power cord. To test your power cord,
do the following:
1. Plug in the air conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will
notice a click as the RESET button pops out.
3. Press the RESET button. Again you will notice a click as the button engages.
4. The power cord is now supplying electricity to the unit.
NOTE:
• Do not use the buttons on the plug head to turn the unit on or off.
• Always make sure the RESET button is pushed in for correct operation.
• The power supply must be replaced if it fails to reset when either the TEST button is pushed, or you
notice that it cannot be reset. A new one can be obtained from the product manufacturer. If the
power supply cord is damaged, it should not be repaired. It MUST be replaced by a power supply
cord obtained from the product manufacturer.
Note: Performance may be reduced outside of these operating temperatures:
Cooling
operation
Outdoor temp: 64-109F/18-43C
Indoor temp: 62-90F/17-32C
WARNING:
– Do not use other means to accelerate the defrosting process, or other means to clean this unit
unless recommended by the manufacturer.
Loading ...
Loading ...
Loading ...