Loading ...
Loading ...
Loading ...
Section 3 - MAINTENANCE
3.5
3.6
EVERY TWO YEARS
3.5.3. Transmission shift lever and detent.
3.5.4. Clutch disc.
3.5.5. Clutch Yoke (See Figure 4.18 on Page 18).
3.5.6. Mower deck linkage and pivot areas.
STORAGE (OUT OF SEASON)
If desired, the Rear Engine Rider can be stored on
the rear bumper. Perform the following
procedures to insure the Rear Engine Rider will
operate properly when taken out of storage.
3.6.1. Thoroughly clean the Rear Engine Rider by
removing all grass clippings and debris.
3.6.2. Perform maintenance and lubrication as
described in 3.3 on Page 9.
3.6.3. Drain fuel from fuel tank.
3.6.4. Start engine and allow it to run until engine
runs out of fuel. This allows the carburetor and
fuel system to remain clean during storage.
3.6.5. Remove battery. See 4.6.5., BATTERY
STORAGE on Page 21.
3.6.6. Close vent on fuel filler cap.
3.6.7. Carefully stand Rear Engine Rider on rear
bumper in desired location for storage.
FUEL
FILLER
CAP
/
FUELTANK
FUEL TANK
REMOVING FUEL TANK FROM
REAR ENGINE RIDER
Before performing any service or maintenance
procedures, always remove key from ignition
switch, remove spark plug wire from spark plug and
secure spark plug wire away from spark plug.
Before removing fuel tank from rear engine rider, move
rider outdoors where fumes can be easily dissipated.
Removal of the tank is most easily accomplished from
the left side of the rear engine rider by pulling the tank
straight up and away from the fuel tank bracket. After
holding the fuel tank in your hands, carefully remove the
fuel filler cap and pour remaining fuel in an approved
container.
13
Loading ...
Loading ...
Loading ...