Loading ...
Loading ...
Loading ...
Door and control panel trim
The metat trim around the door and the control panel can be cleaned with any
nonabrasive cleansers such as Bon Ami or soapy water, rinse wetl. Be careful not to
use an excessive amount of water.
Glass on the oven door front
To ctean, use any suitable glass cleaner or soapy water. To prevent moisture from
gettingbehind the glass control panel, spray a cloth with glass cleaner then wipe the
panel
Control Panel
Wipe with a damp cloth. Dry thoroughly. Do not use cleaning sprays, large amounts
of soap and water, abrasives, or sharp objects on the panel. They can damage it.
To remove pull forward to the "stop" position;
liftup on the front of the rack and pull out.
The oven temperature can be adjusted ifthe oven temperature istoo low or too high and
the length of time to cook ALL foods is too long or too short. DO NOT adjust the
temperature if only one or two items are not baking properly.
To adjust
1, Touch Bake Pad,
2. Touch and hold the Up Arrow Pad until 500_F or higher appears in the Display.
3. Immediately, touch and hold the Bake Pad for several seconds until 00° appears
in the display.
4. Touch the Up or Down Arrow Pads to select the temperature change desired. The
oven temperature can be increased up to35° or reduced by as much as 35° (display
would show -35°) in 5° increments.
Note: If you delay inselecting a temperature, the program willautomatically cancel
and 00° will disappear. Begin at step 1 again.
5. Touch the CanceltOff Pad and the time of day will reappear in the display. The oven
will now bake at the adjusted temperature.
Note: It is not necessary to readjust the oven temperature if there is a power
interruption.
Important: The oven temperature should be adjusted no more than 10° and then the
oven should be tested. (We recommend baking 2 - 9" yeltow layer cakes using a
purchased box mix.) If the oven temperature is still too low or too high, repeat the
procedure described above.
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker
panel. Be sure that the entire oven cavity including the light bulb is coo] before attempting
to remove.
To replace
1, Carefully unscrew the glass light iens.
2. To obtain firm grasp on bulb, wear protective rubber
gloves. Remove by turning bulb to the left. Do not touch
a hot oven light bulb with a damp cloth as bulb will break.
Note: If the bulb does break and you wish to remove it,
be certain power supply is disconnected and wear protec-
tive gloves. You may contact your authorized Jenn-Air
Service Contractor for service.
3. Replace bulb with a 40 watt ovemrated appliance bulb.
Burb with brass base is recommended to prevent fusing of
bulb into socket.
4. Replace bulb cover and reconnect power to oven. Reset
clock.
EJ
24 25
Loading ...
Loading ...