Loading ...
Loading ...
Loading ...
Page 23 of 60
Thermostat, Digital On/Off Remote or Wall Switch Installation
Mount the thermostat, digital on/off remote or wall switch in the desired location and run “two
conductor thermostat wire” to the unit’s lower right hand corner, close to the gas supply line.
Monter le thermostat numérique, télécommande marche / arrêt ou l'interrupteur mural à l'endroit
désiré et exécuter "les deux fils du thermostat d'orchestre" au coin de l'appareil en bas à droite, près
de la ligne d'alimentation en gaz.
1. Purchase “two conductor thermostat wire”, which is not provided, at any local supplier. The
gauge of thermostat wire will determine the maximum wire length and distance at which to
locate the thermostat, digital on/off remote or wall switch. See Table 1 and the information
packaged with thermostat. Be aware that as the length of wire increases, the probability of
adequate operating voltage decreases.
Achat "deux fils du thermostat d'orchestre», qui n'est pas fourni, à tout fournisseur local. La
jauge de fil de thermostat de déterminer la longueur de câble maximale et la distance à
laquelle de localiser le thermostat numérique, interrupteur marche / arrêt à distance ou au
mur. Voir le Tableau 1 et les informations fournies avec le thermostat. Soyez conscient que la
longueur du câble augmente, la probabilité de la tension de fonctionnement adéquat diminue.
TABLE 1 THERMOSTAT WIRE INFORMATION
WIRE SIZE
MAX. WIRE LENGTH
AWG
mm
ft.
m
22
0.6
10
3.0
20
0.8
25
7.6
18
1.0
40
12.2
16
1.3
64
19.5
14
1.6
100
30.5
2) After the unit is installed and the gas line hooked up, crimp a fork connector to each wire and
attach them to the TH/TP and TH screws located on the valve.
Après que l'unité est installée et la conduite de gaz accroché, sertir un connecteur fourchette pour
chaque fil et les joindre à la vis TH / TP et TH situé sur la valve.
3) Check tests can be performed on the valve by using the trouble-shooting guide, Section 5.0.
Vérifiez les tests peuvent être effectués sur la valve en utilisant le guide de dépannage, la
section 5.0.
4) This switch may be connected in parallel with a thermostat, digital on/off remote or wall switch
(see Figure 4).
Ce commutateur peut être connecté en parallèle avec un thermostat numérique, télécommande
marche / arrêt ou un interrupteur mural (voir Figure 4).
NOTE
The thermostat, digital on/off remote or wall switch MUST be rated for millivolt use.
Minimize splicing in all millivolt wiring & crimp all unavoidable splices.
Le thermostat numérique, télécommande marche / arrêt ou l'interrupteur mural doit être
évalué pour une utilisation en millivolts. Minimiser épissage dans l'ensemble du câblage
millivolt & sertir toutes les épissures inévitable.
Loading ...
Loading ...
Loading ...