Loading ...
Loading ...
Loading ...
When loading the clothes into your washing
machine, there are three things to remember:
Clothes must be loaded evenly in the wash
bowl. For best results load small items first,
followed by large items.
When using the washing machine for the first
time, check that the dispenser is set for the type
of detergent you will use. To do this, proceed as
follows:
Pull the dispenser drawer forward until it
stops.
Load the Washing Machine
1.
2.
The washing machine must not be overloaded.
Clothes must be able to move during wash.
The load should contain only three or four large
items, for example sheets. The rest of the load
should be small items. A mixed load of large
and small items will wash cleaner than a load of
all large items.
3.
Add the Detergent
Detergent and Fabric Softener Use
clip flap down for
liquid
5 Simpson Washing Insructions
Caution
Do not spill fabric softener on the clothes as
it may stain them.
Don’t use the wrong type of detergent. You must
use a low sudsing detergent designed for front
load washing machines or high efficiency top
loaders, such as Cold Power for Front Loaders
and High Efficiency Top Loaders or detergents
labelled ‘Matic’.
Don’t use soap-based products in your washing
machine.
Don’t use too much detergent. This can result in
excessive suds that can cause low spin speeds,
poor rinsing and overloading the motor during
spin stages of the wash program.
Don’t use too little detergent because you will get
a poor wash. If you think you need more, increase
dosages by only small amounts to avoid excessive
suds.
1.
Lift the front of the drawer up and forward to
remove it from the runners.
2.
Check the position of the flap at the rear of
the detergent compartment in the dispenser
drawer. (Factory setting is flap up for powder.)
3.
Clip the flap down if you intend to use liquid
detergent.
Remember: If you change the type of
detergent you use, the position of the
flap will need changing. See above.
4.
You are now ready to add detergent.
Measure the amount required and pour it into
the detergent compartment of the dispenser
drawer.
When using liquid detergent, some may leak
out of the dispenser into the wash load earlier
than expected through small openings in the
back of the dispenser. The openings are to
help flushing out of detergent.
6.
Refit the dispenser back into its runners.
5.
add detergent
clip flap up for
powder
Loading ...
Loading ...
Loading ...