Loading ...
Loading ...
Loading ...
LOWER
BLADEGUARD
BLADE _HILLIPS
SCREW
TO
LOOSEN
FLAT(S)
ONSPINDLE
TO
TIGHTEN
BLADE
BOLT
OUTERBLADEWASHER
WITH DOUBLE"D" FLATS
INNERBLADE
WASHERWITH
DOUBLE"D"FLATS
Fig. 19
• Remove outer blade washer. Do not remove inner
blade washer.
• Wipe a drop of oil onto inner blade washer and outer
blade washer where they contact the blade.
_ WARNING: If inner blade washer has been
removed, replace it before placing blade on spindle.
Failure to do so could cause an accident since blade
will not tighten properly.
• Fit blade inside lower blade guard and onto spindle.
The blade teeth point downward at the front of saw as
shown in figure 19.
,_ CAUTION: Always install the blade with the blade
teeth and the arrow printed on the side of the blade
pointing down at the front of the saw. The direction
of blade rotation is also stamped with an arrow on
the upper blade guard.
• Replace outer blade washer or the laser guide (see in-
structions on the following page). The double "D" flats
align with the flats on the spindle.
• Depress spindle lock button and replace blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt counterclockwise to tighten.
• Tighten blade bolt securely.
• Replace the lower blade guard and blade bolt cover.
• Retighten phillips screw securing blade bolt cover.
Tighten screw securely.
A
CAUTION: Make sure the spindle lock button is not
engaged before reconnecting saw to power source.
Never engage spindle lock button when blade is
rotating.
SPINDLE
LOCK
Fig. 20
2O
Loading ...
Loading ...
Loading ...