Loading ...
Loading ...
Loading ...
UNPACKING
This product has been shipped completely assembled.
• Carefully lift saw from the carton by the carrying handle
and the saw base, and place it on a level work surface.
NOTE: This saw is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
• Your saw has been shipped with the saw arm secured
in the down position. To release the saw arm, push
down on the top of the saw arm, cut the tie-wrap, and
pull out on the lock pin.
• Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the tie wrap.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
• Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
• The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
• If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
WARNING: If any parts are missing, do not operate
this tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
A
WARNING: Do not attempt to modify this tool
or create accessories not recommended for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
_ WARNING: Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
MOUNTING HOLES
See Figure 8.
_ WARNING: Always make sure your compound
miter saw is securely mounted to a workbench or an
approved workstand. Failure to heed this warning
can result in serious personal injury.
Your compound miter saw should be permanently
mounted to a firm supporting surface such as a work-
bench. Four bolt holes have been provided in the saw
base for this purpose. Each of the four mounting holes
should be bolted securely using 3/8 in. machine bolts,
lock washers, and hex nuts (not included). Bolts should be
of sufficient length to accommodate the saw base, lock
washers, hex nuts, and the thickness of the workbench.
Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in
figure 8. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
TRACEHOLES
ATTHESELOCATIONSFOR
HOLEPATTERN
\o C]
\
TRACEHOLES
ATTHESELOCATIONSFOR
HOLEPATTERN
BASE
MOUNTINGSURFACE
Fig. 8
15
Loading ...
Loading ...
Loading ...